This thermal fuse is used in dryers as a safety mechanism that stops the flow of electricity to the motor circuit when a dryer overheats. This replacement part features two 3/16 inch terminals, and is sold individually. When this fuse is faulty, your dryer will not start or it will not heat properly. This is a one-time fuse, meaning it cannot be re-set. It must be replaced when there is no longer continuity between the terminals. It attaches to the blower wheel housing. Blown fuses can be caused by clogged dryer vents. We recommend checking to make sure all of the vents are clear when you perform this repair.

This replacement light bulb is sold individually.

This kit contains two door strikes, and three door catches to service dryer doors that have one or two catches.

This door closing cam is located on the bottom of the fridge/freezer door.

This 40W light bulb has a small screw in base. It screws into the bottom panel of your microwave.

This coupling kit is located between the motor and the transmission on direct drive washers with no belt. This is the newer version and is made with new metal sleeves for added strength.

These agitator directional cogs are commonly referred to as dog ears. They come four to a package and are usually used with direct drive washing machines.

This dryer drum belt has four ridges, three grooves and is 1/4" wide.

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. This capacitor is also known as a run capacitor, and it is most often used in refrigerators and freezers. This part provides the voltage or energy current required to start the compressor and keep it running. It allows the compressor in your appliance to easily cycle on and off. Doing so enables the appliance to effortlessly maintain its internal temperature. If the capacitor is faulty your refrigerator or freezer might be too warm, or you may notice the compressor will hum, but it will not run. When replacing your capacitor, you should check the old one for any signs of damage, overheating, or arcing, as that may suggest there is a bigger problem with your appliance.

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two terminal secondary coil. Usually only one of them burns out but you should replace them as a set. Both have to be operational for the gas valve to open.