The Oven Bake Element is a black, metal part which supplies heat to the oven. This element is 19-1/2" wide x 18-1/2" long and has 3-1/2" inserts. It is rated as "Easy" to install by users, and attaches to the bottom of the oven. If you notice visible damage, or that your oven is not receiving heat properly then it may be a problem with this part. Check your model number and user manual to see if this is the right part for you. It is important for you to disconnect your appliance from the power source before performing this repair. After disconnecting your appliance, remove the two screws/nuts connecting the old element, pull it out, and discard if faulty. Simply connect the new element prongs where the old element fit, and screw it back in. You may need a flashlight when making this repair.

This surface burner terminal block kit comes with interchangeable mounting brackets, terminal box, ceramic wire nuts, heat shrink protective tubing and wires.

This drip bowl is located beneath the element and catches any spills. It is sold individually and has a diameter of approximately 10 inches.

This drip bowl is sold individually. This part is located beneath the element and catches spills from cooking.

This coil element has looped terminal ends.

This flat style gas oven igniter has an amperage range between 3.2 to 3.6. This part comes with two ceramic wire nuts.

Terminal blocks (also called terminal boards or strips) provide a convenient means of connecting individual electrical wires.

This rear drawer glide is for your bottom range drawer. It is sold individually.

This front drawer glide is for your bottom range drawer. Your range has 4 in total. This drawer glide is sold individually.