This replacement light bulb is sold individually.

The flat style gas oven igniter included in this kit has a body length of 3-3/4 inches. This kit comes with all of the pieces you need to replace longer ceramic igniters, though this kit can also replace short igniters. This igniter has an amperage range of 3.3 - 3.6 and does NOT replace round style oven igniters.

This eight inch chrome drip bowl is intended for use with many electric ranges and cooktops.

This dryer drum belt has four ridges, three grooves and is 1/4" wide.

This 40W light bulb has a small screw in base. It screws into the bottom panel of your microwave.

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

This drip pan is located beneath the element and catches any spills. It is sold individually. This is an original part Whirlpool part for use with Ranges. The drip pan catches spills from the cookware on the surface burner. This part is sold individually. This drip bowl is chrome, and it has a diameter of 8 inches. You need to remove the burner element to replace this part. Drip bowls need to be replaced when they are lost, damaged, or you are no longer able to clean them adequately. There are no tools needed for this repair.

This condenser fan motor operates in a clockwise fashion and carries carries 2W and 115V. It comes with screws, a mounting nut for the blade and a cushion. This part provides forced-air cooling for the condenser coil.

Also known as Thrust Bearing Kit. This kit includes the pulley, washer, thrust bearing, 2 upper race washers and 1 lower race washer. These parts are NOT available separately - they are ONLY available in this kit. A worn bearing causes slow or no spin.

This kit comes in two pieces: the catch and the clip.