Washer Water Inlet and Valve Assembly WPW10683603

Does this come with solenoids?

Is there a screen in the water inlet port? My washer has a very low water pressure into the machine. It is not in the water line. Do i need to replace the machine?

I bought this washer two years ago am i going to have to replace this every two years

Remove part no w10423125

This four year old washer behaves as follows; any cycle selection, - pushing the start button, the left light lites, the lid log makes a noise and engages, the agitator turns slowly, and then the lid lock disengages. No water flow at all. Checked hoses and filters. Both good. Is this a typical lid latch issue or a water valve issue or is there another problem. The issue(s) have happened over a few weeks, firstly the tub would not fully drain, and now it does virtually nothing except be powered. With the cost of the various parts, it may be cheaper to simply buy new. Certainly cannot afford a repair professiona. However, i would think that a four year old machine would not become obsolete.

Hello, i asked earlier about the washer flashing code f8e1, i was told to check the air pressure tube for damage and i did not see any damage on the tube even blew threw it and didnt feel any air. The inlet valave seems to be in good condition, i dont see any warping or anything like that. When i took the back of the washer off and the removed the drain tube water came out, could there be something wrong with the pump? Or does the code f8e1 only mean the pressure tube and valve? If it helps any the washer goes through the cycle and by the time it gets to spin it will spin once and then the lights turn off but the lock lid light and it makes noises and then that light turns off and the wash light will turn on and just sit there, the clothes are still wet when i open the lid. However the only code flashing is f8e1.Thank you for the help

This is just a follow up from my last two questions about my washer. I did check the lid lock and its okay, i can even put the washer on drain and spin and it does just fine. However its still doing what i described in my last message about getting to rinse and then the Green lights turning off and just the lid lock light stays on and i can hear the pump or drain doing something and then the lid light turns off and it goes to wash and just sits there, the same error code is coming up as f8e1. The water is going into the machine just fine as well.....would it just be safe to assume i should go ahead and just get a new pressure hose and replace it incase there is a hole or something wrong somewhere that im not seeing? i just dont want to buy 10 different parts to fix one thing. thank you for all the help!

Can i replace just the two electronic magnet devices on my washer on the water inlet valve

The washer was filling very slowly, so we removed screens and at the time removed some plastic water diverter? Inside water valve, now the washer just keeps filling up and it doesn't stop, and the wash cycle isn't finishing? We are trying to find replacement part for that small plastic thing we took out, please help?

This washer does not fill with hot water. The hot water inlet solenoid seems to open and close intermittently. Will replacing the water inlet valve assembly solve this problem?