11022442510 Kenmore Washer - Overview

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.

If your washer isn’t filling properly, keeps running water, or has a leak at the back, the water inlet valve might be the problem. This part controls how much hot and cold water enters the machine and helps keep the temperature balanced. It also makes sure the washer doesn’t overfill. Swapping out a worn valve can fix issues like slow fills, leaks, or uneven water temps and get your laundry routine back on track.

The drain hose carries used water from the washer to your house drain.

This part is the replacement lid latch or latch assembly for your top-load washer. The lid latch holds your washer door closed, and allows the washer to run its cycle. If the lid latch is damaged, your washer door may not close properly and you may not be able to run your washer. The latch is found under the lid and can be screwed out and...Read more replaced. You will need a Phillips-head screwdriver for this repair. This part is sold individually and is and OEM part from the manufacturer.

This screw is sold individually.

This insert is sold individually. Knob not included. Knob is sold separately.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

This clamp helps to prevent leaking by holding the end of water hose in place.

This is the bearing for the lid hinge. Sold individually.

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".