Agitator Cap WP3355758

I simply lifted the lint filter and its cap off, pressed the new agitator cap onto the new lint filter and put the assemblage into place. No tools needed at all. A $50 dollar repair saved me from replacing my washer/dryer! I'm very pleased.

I pulled the cap and took a socket wrench turned the stud agit off and removed the upper agitator. Than I assembled the new agitator with the new clogs put the agaiator back on and tightened the stud agit. Replaced new cap and done! Easy job!! Everything is working like new again. This whirlpool washer is 14 years old and still going strong!

First I removed the top cap on the agitator, then I removed the second cap inside the agitator. I moved the agitator with my hands and saw that the "dog ears" were worn and no longer touched the agitator and couldn't move it. I then used a nut driver to remove the nut that held the top portion of the agitator onto the bottom portion. I made a note of the worn parts, got online at PartsSelect.com and ordered the replacement parts. A few days later the parts arrived and I repeated the above process in reverse using the new parts. It now works like new!!! It wasn was very easy. Thanks!!!

just switched the parts it was a no-brainer
i did not need to replace the stud

I just lined up the tabs with the slots on the spindle and it snapped right on with small amount of pressure. The cap also snapped right on. Might as well replace the cap for and extra 6 bucks if you have to replace the agitator.

Just replaced it.

Took off the old agitator and put the new one on, then placed the cap on top and pushed down really hard until it clicked

Repairs went well.....it took less than 10 mins...just followed picture diagram....and test....and it worked well>>>.