KGCD807XBL00 KitchenAid Cooktop - Instructions

Remove old knob. Replace with new knob.

First I tried twitching my nose....after I stopped sneezing I got a screw driver and put the new electrode in and gosh in gahiggy, it worked!!

First step is to turn gas off to cook top and also disconnect power to the unit. Than using a crescent wrench disconnect the gas line going to the unit from the Regulator. Than again using the crescent wrench disconnect the regulator from the bottom of the unit. Next remove the nipple that connects the gas line to the regulator from the old unit. Apply new pipe dope to the threads and screw it into the new one and tighten down. Next install the regulator to the unit and install the gas line to the regulator. once done with the install you can now plug the unit in and turn on the gas. You are now ready to use the cook top again

Took broken knob off and slid the new one on. DONE!!!

So simple -- any monkey could do it. Pull off the old knobs and push on the new.

Removed old knobs and replaced with new ones.

We have had this appliance for 18 months. Within one month the first knob broke. A month later, the second knob broke. We have gently been using the remaining 2 knobs for 4 burner positions until recently when the other 2 broke. I am hoping these new knobs are made better then those that came with the appliance.

First went to an appliance distrib. store.They would have to part.Was qouted a price.Wenthome and went online to partselect.com and saved 40% even with shipping.Got the part the next day!Pulled old knob off and pushed new knob on.Thank you for making it easy.

The part was here three days after ordering and I put it on with no tools in less than a minure.

Got on line and ordered part and lined up flat side of inside of knob and slid it on... That simple... The person who put them on after cleaning stove never knew there was a flat side inside knob.. We never stop learning, do we???

I carefully pulled the 3 D rings that were left on the posts of the burner controllers with a pair of needle nosed pliers, made sure there was nothing on the controller posts, then put the new knobs on. Make sure there are no D rings on the oven knob posts, 2 of the knobs were fine, they just didn't have D rings in them. Partselect was great. Items were received within 2 days. I would definately recommend them.

with my own two hands, just slip it on--- no story.you folks came through quikly with no complications and deserve a compliment.

Do not buy just the burner electrodes. The screws that hold the electrode will break off. Purchase the burner head with electrode. I would recommend placing anti-sieze lub on the new screw that holds the electrode to the burner head so if the electrode fails again it can be replaced. The screws that hold the burner head to the top top are mild steel and will rust and snap off. I would use a rust penatrent on these screws several days before trying to remove but most likely they will strip or break off. Replace all these burner head screws with stainless steel screws with anti-seize applied. If any of this sound difficult call a repair company.

Take old off and put new on

bought new ones and pushed them onto D shaped posts total time 90 seconds they may break again in 10 years but I am to lazy to reinforce them