BX521VCPWR (P1325030W W) Amana Refrigerator - Instructions

Removed old gasket with nut driver and installed new one. Very easy, wife happy. What more could I ask for.

First I watched the video then I removed screws,removed old gasket,cleaned face,set a few screws loosely, tucked in new gasket,replaced screws tightly, turned freezer on and taped door.Just like Jim on video told me. THANKS!!!

I ordered the part and it arrived VERY quickly and was very easily installed. I was delighted that it was something I could do myself and didn't have to bother my husband. Victory! I would order parts from here again if the need should arise.

A very cold and brittle switch in a 17 year old fridge. Used screwdrivers to pry out with some resistance Had to cut the molded plug in half and split wires, because replacement contacts were farther apart than the original. End result, works great.

After watching the video, I followed the instrutions and was pleased at how well the video presented the repair.

I removed the freezer door and unscrewed the panel and rermoved the old gasket then replaced it with the new gasket and reattached it. very easy took timre to clean the freezer. thank you for the quick delivery.

Remove old gasket by pulling off. Remove inner door panel by removing about 40 small screws. Used a speed wrench and small socket. Place new gasket on door panel and bolt on, starting at top center, bottom corners, etc. Took about 45 minutes.

after removing inside panel the insulation had ice formed on allthe edge. I used a blow dryer to loosen the insulation & replaced it. Put the gasket on & screw the inside panel back on.

The repair was relatively simple: Remove all the screws/fasteners with a nut driver. Separate the door liner from the door frame. Remove the old gasket. Fit the new gasket to the door liner and align with the holes in the door frame. Replace the screws.

It was not an easy job. Had to have help. When the job was finished, there was a gap between the gasket and the door. I had to put a 2 x 4 and a shim to keep it closed..

I used a cordless drill to undo the screws with a socket, placed the new gasket down and around the inside housing. Retighten the screws. I only had a problem with the inside door housing because i flipped it upside down my mistake, so i had to correct it by undoing the screws again and start over. But still i don`t even think it took an hour.
Very simple, just remmeber to keep the inside housing top at the top and you won`t have to do it twice like me.

Pried out ice blade bar and removed broken water fill cup and replaced with new one.The whole repair costs $9.52 So I saved $ 190 over the cost of Appliance man visit!
It would have been $150& $50 for visit to replace ice maker unit.

Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!

I entered the model number and was easily able to find the replacement part I needed. It arrived two days later and I installed it and now my fridge works as good as ever. Thanks I felt so smart.

I took the old gasket off and popped the new gasket on in less than a half hour. It really was that easy. I used my cordless drill to remove all the screws and it made it fast