66512776K310 Whirlpool Dishwasher - Instructions

The instructions that were included were a bit scetchy, but we figured it out. I like that the replacement part is made of medal and not plastic. We first put the clips on top then figured out they go below middle bar after that it all came together

Followed the instructions included with the kit, took a little while to figure out what the photos were showing. But essentially installation was easy.

Pulled old broken parts off with a little brute force. Installed the new parts and pieces, per directions provided (with pictures!), and placed back in dishwasher. It was easy! Made sure to install new wheel tracks forth set of tines from back of basket, slide parts into place and secure with screws provided. Only extra tool needed is a Phillips head screwdriver.

Figured out what was worn and went to website to order replacement parts. Three days later the parts show up, I find the replacement parts are better build than the original parts. Took less than 30 minutes to repair and reinstall. Works perfect. Website was easy to use and the repair was simple.

replaced both sides of rack with the new metal parts. easy to do once you realized you what part went where. the instruction pictures could have been bigger or clearer.

Followed the written instructions provided with the new adjuster replacement kit. No problems with the removal and replacement of the adjusters.

Removed upper rack.Replaced both side rack adjusters purchased from Kitchen Aid. Replaced upper rack and checked for easy operation. They were made superior to original parts, what I would call an upgrade. The instructions are well written easy to follow and in order of completion. One word of advice, dont snap keepers in place untill you are sure they are in correctly. The picture quality could be improved to better assist anyone not used to doing these type of tasks.
D Burton

Instruction sheet is good but should stress that the thumb pads must face the front side of the dishwasher.

Removed old adjuster rack from both sides using a screw driver. Followed directions provided with rack adjuster kit and installed new adjuster on both sides.

This was my 4th time replacing these parts. Old parts where all plastic and I was lucky to get 6 months before they all disintegrated from the hot water washing. New parts are steel and replacing the old plastic parts was a piece of cake. Looks and even feels much stronger! Excellent youtube video

Ordered the parts and installed them according to the enclosed instructions & photos that came with the repair parts.

The repair was easy. The replacement parts fit perfectly and the instructions were great.

It was so easy! Broke of the already broken supports and followed the easy step by step instructions with pictures.

The repair kit was easy to install, required a torque tip screw driver and thin flat head screw driver to remove the old parts. Took me 15 minutes start to finish. Simply follow the instructions provided with the kit. Nothing else needs to be said.

You have to go online and watch a video of how to install the replacement part. Ten or so minutes later you are done.You tube makes everything easier.