Jenn-Air Washer Parts

Transmission Pulley and Bearing Kit

★★★★★

★★★★★

10 Reviews

Also known as Thrust Bearing Kit. This kit includes the pulley, washer, thrust bearing, 2 upper race washers and 1 lower race washer. These parts are NOT available separately - they are ONLY available in this kit. A worn bearing causes slow or no spin.

Snubber Ring

★★★★★

★★★★★

16 Reviews

Drive Belt - 51 inches long

★★★★★

★★★★★

13 Reviews

This V-style drive belt is about 51" long and 3/8" wide. This part is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt encounter wear and tear.

Drain Pump with Pulley

★★★★★

★★★★★

12 Reviews

This pump has 2 ports. This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

Hose Clamp This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

Transmission Lower Lip Seal Repair Kit This transmission lip seal repair kit comes in two pieces: a red four inch long piece, and a black one inch long piece. Both pieces are made entirely of plastic. This repair kit comes with and instructions sheet and it is used for some washing machines.

Lid Hinge Pin

★★★★★

★★★★★

6 Reviews

This lid hinge pin is just over an inch long. It is all white in color and is made entirely of plastic. Sold individually.

Lid Hinge

★★★★★

★★★★★

7 Reviews

This lid hinge in an inch and a half long and is used for some washing machines. It is all white in color and it is made entirely of plastic.

Motor Pivot Spring This part is the replacement motor pivot spring for your washer. It is made of metal and is approximately 3 inches long and 2 inches wide. The motor pivot spring helps hold the drive motor in the correct position on the motor plate. If your drive motor shakes during use, if the pumps will not operate, or if your washer is excessively loud during operation, you may need to replace the motor pivot spring. Be sure to disconnect the washer from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Hose Clamp This hose clamp is sold individually.