Whirlpool 12002213 - Transmission Pulley and Bearing Kit | PartSelect.ca
Transmission Pulley and Bearing Kit – Part Number: 12002213
Transmission Pulley and Bearing Kit – Part Number: 12002213 Transmission Pulley and Bearing Kit – Part Number: 12002213 https://partselectca.azureedge.net/Schematics/Maytag/48342.gif

Transmission Pulley and Bearing Kit

2 Reviews

Your Price

CAD$57.04

PartSelect Number PS2003651
Manufacturer Part Number 12002213
Manufactured by Whirlpool

Also known as Thrust Bearing Kit. This kit includes the pulley, washer, thrust bearing, 2 upper race washers and 1 lower race washer. These parts are NOT available separately - they are ONLY available in this kit. A worn bearing causes slow or no spin.

This part works with the following brands: Maytag, Norge, Admiral, Magic Chef, Crosley, Amana, Hoover, Jenn-Air, International.

This part works with the following products: Washer.

This part fixes the following symptoms: Pumps but will not spin | Noisy | Spins slowly | Will not agitate

Videos For installing this part.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.8 / 5.0, 24 reviews What's this?
1-5 of 24
331 of 375 people found these instructions helpful
Parts Used:
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Socket set
Customer:
James from Hueytown, AL
Washer tub would not spin, pump would empty water from tub.
Lay washer on front, removed belt. Removed center pulley with thrust bearing (pulley was worn on upper end, against thrust bearing, thrust bearing was worn also). Installed new thrust bearing & pulley kit. Cleaned & lubed slots that motor insulators slide in, installed new belt.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

114 of 132 people found these instructions helpful
Parts Used:
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers, Socket set
Customer:
MICHAEL from PLYMOUTH, MN
Pump making horrible noise and brake stuck
The pump was very easy to replace (3) screws, easy to reach with front panel off. (Less than 5 minut job. The brake assembly and thrust bearing was a little harder to do, but not bad at all. I found it best to flip the unit upside down to do the brake assembly. Replaced #10-24 x 1/2" screws with 2" long ones. Remember to do this (1) at a time, then back all (6) off a little at a time to release tesion on the 200lb spring. Swap out parts and tighten back down with 2" screws and then swap them back out for the 1/2" ones (1) at a time. I tipped the unit back on its side to install the bearing & pully kit. This takes some of the weight off of the main shaft allowing you to insert the spacers and split ring. The replacement parts seem to be of eqal or better quality to the originals. Machine runs quiet and smooth.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

57 of 68 people found these instructions helpful
Parts Used:
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Pliers, Screw drivers, Socket set, Wrench set
Customer:
steve from lebanon, OH
Washer would agitate, pump, but not spin
First I unplugged it, then removed the agitator and tub assemblies, then I tipped it back and removed the belt and pully and thrust bearings. After reading on here I learned the brake would stick and after installing the thrust bearing kit I found out I couldnt fit in the shims. That led me to believe the brake was siezed inplace so i couldn't fit in the parts. I removed the thrust bearing kit and removed the transmission assembley. I took apart the brake and found the two pieces had siezed together, after I got them apart I sanded both peices and lubed the shaft with high temp silicone like you would use on a cars brake system. I put the brake back together, BE VERY CAREFUL THE SPRING HAS ALOT OF PRESSURE! I then put the transmission back in, reinstalled the thrust bearing kit and it fit great. I put in the tub and agitator and washed clothes.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

39 of 44 people found these instructions helpful
Parts Used:
  • Transmission Pulley and Bearing Kit
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench (Adjustable)
Customer:
michael from mountain home, ID
Washer would agitate, drain, but would not spin
I put the washer on the spin cycle and could see that the tub wanted to move. While it was trying to spin I leaned the washer forward and saw that the motor was spinning and the belt was turning, but the tub wasn't. Did some reading and it was the thrust bearing. I ordered the part and replaced them (very easy, follow the directions that come with the set). After install, the tub would spin.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

39 of 44 people found these instructions helpful
Parts Used:
  • Transmission Pulley and Bearing Kit
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Customer:
marcus from mansfield, TX
Washer would not spin water out in heavy loads
You do not have to remove any water lines to do this repair. Just unplug the machine from the electric outlet and tip it up on its back to make the repair. I removed the old belt and parts per the instructions. The new kit does not look like the old one. Make sure you mark the minimum and maximum marks with a sharpie on the plastic pulley before intalling it. This will help line up the cam bearing to test the spin cycle. The repair kit says to use the thickest washer but mine would not fit on so I used the thinner washer. Keep the other washer so that in the future if the plastic part wears down and you have spinning problems again you can replace it with the thicker washer. Also make sure you buy a new belt and replace the belt. I loaded it up with a full load of jeans and it works great.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-5 of 24
Customer Reviews
Average Rating:
2 Reviews
4
out of 5
Filter By Rating:
  • 5 Stars
    0
  • 4 Stars
    2
  • 3 Stars
    0
  • 2 Stars
    0
  • 1 Stars
    0
Sort by:
Sort by:

Model Cross Reference

Brand
Model Number
Description
Norge
6002A
Washer - WASHER
Norge
6002A REV A
Washer - Norge Washing Machine Model 6002A REV A (6002AREVA) Parts
Norge
6430
Washer - WASHER
Norge
6430 LOT A
Washer - Norge Washing Machine Model 6430 LOT A (6430LOTA) Parts
Norge
6430 LOT A REV A
Washer - Norge Washing Machine Model 6430 LOT A REV A (6430LOTAREVA) Parts
Norge
6430 LOT A REV B
Washer - Norge Washing Machine Model 6430 LOT A REV B (6430LOTAREVB) Parts
Norge
6432A
Washer - WASHER
Norge
6432A REV A
Washer - Norge Washing Machine Model 6432A REV A (6432AREVA) Parts
Norge
6432A REV B
Washer - Norge Washing Machine Model 6432A REV B (6432AREVB) Parts
Norge
6432A REV C
Washer - Norge Washing Machine Model 6432A REV C (6432AREVC) Parts
Norge
6432A REV D
Washer - Norge Washing Machine Model 6432A REV D (6432AREVD) Parts
Norge
6433A
Washer - WASHER
Norge
6440A
Washer - WASHER
Norge
6440A REV A
Washer - Norge Washing Machine Model 6440A REV A (6440AREVA) Parts
Norge
6440A REV B
Washer - Norge Washing Machine Model 6440A REV B (6440AREVB) Parts
Norge
6440A REV C
Washer - Norge Washing Machine Model 6440A REV C (6440AREVC) Parts
Norge
6440A REV D
Washer - Norge Washing Machine Model 6440A REV D (6440AREVD) Parts
Norge
6440A REV E
Washer - Norge Washing Machine Model 6440A REV E (6440AREVE) Parts
Norge
6440A REV F
Washer - Norge Washing Machine Model 6440A REV F (6440AREVF) Parts
Norge
6440A REV G
Washer - Norge Washing Machine Model 6440A REV G (6440AREVG) Parts
Norge
6440A REV H
Washer - Norge Washing Machine Model 6440A REV H (6440AREVH) Parts
Norge
6440A REV J
Washer - Norge Washing Machine Model 6440A REV J (6440AREVJ) Parts
Norge
6440A REV K
Washer - Norge Washing Machine Model 6440A REV K (6440AREVK) Parts
Norge
6443A
Washer - WASHER
Norge
6443A REV D
Washer - Norge Washing Machine Model 6443A REV D (6443AREVD) Parts
Norge
6443B
Washer - WASHER
Norge
6530A
Washer - WASHER
Norge
6530A REV A
Washer - Norge Washing Machine Model 6530A REV A (6530AREVA) Parts
Norge
6530A REV B
Washer - Norge Washing Machine Model 6530A REV B (6530AREVB) Parts
Norge
6530A REV C
Washer - Norge Washing Machine Model 6530A REV C (6530AREVC) Parts