RB1005XYW2 Whirlpool Wall Oven - Instructions

I tokk two srews out, pulled element out, disconnected wires, put wires on new element, put screws back in, turned the breaker back on , now oven heats up fine.

The part came as promised & and it was exactly the right part! I turned off the breaker to the oven (the oven has a clock and timer on it too). Unscrewed the 2 screws with a Phillips screw-driver and carefully removed the old part - being very careful to be safe and not make a big mess. It was easy to disconnect the wires and get the old element out. Then connected the wires to the new element, placed into position, screwed in the 2 screws, and turned on the breaker. It worked great. Then set the clock because it was 13 minutes slow!

Removed the 2 screws in back of the oven that hold the element in place. Pulled the wires out and removed the element. Attached the new element and inserted the screws.

Pop old one out and new one in

turn off electric breaker, unscrew the 2 screws unplug the 2 ends replace old element with new repeat previous steps but unfortunately the control panel was also failing and that item has been discontinued.

replaced light socket but did not repair problem. must have burned the motherboard.


pleased with service from your company.

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.

unscrewed two screws, unpluged two wires, put screws back. turn off power!

I first went to the breaker box and shut off the power to the oven.
Then I pulled the 2 screws from the back of the oven that held the element in and pulled off the clips and removed the old element.
My wife decided to give the old oven a good cleaning with a non-fuming cleanser while I went out to play golf.
When I came home she had applied the 2 clips to the new element and fastened it in with the 2 screws. (I love it when women use tools!)
The oven now looks and works like new!

1. Unscrewed glass cover on bulb
2. Removed old bulb
3. Screwed in new bulb
4. Replaced glass cover
5. Mixed drink & baked cupcakes

Easiest repair I have ever done.
Removed two screws and pulled element out, exposing wiring. Pulled wiring connection apart with pliers. Attached wiring to new element and inserted element back in place and replaced screws. All done!!!
It worked.

First removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires...then replaced the old element with the new element..........(worked perfectly)

Replaced element.
Looks like I saved at least 500$
Geuss I'm Winning!
:)

Unscrewed two small screws and took the old element out, and installed new element. It took less than ten minutes to repair. The new element works beautifully.