PFSF6PKXCBB General Electric Refrigerator - Instructions

Removed clear cover from old frame with screwdriver and replaced it on new frame. I had no problems and everything looks and works good. Took about 10 minutes. Easy job.

I watched the video, and noticed that they did not even turn off the water. The replacement took less than 30 seconds once the filter was filled with water.

it was easy. Open the fridge,untwist the old filter. Open the new filter, fill with tap water and twist in place. Run water through it for a few minutes to insure it is working and filters the water.

Remove Ice maker tray and remove one screw on left side holding wire harness cover on. Remove wire harness cover, disconnect wire harness, pull out Ice Maker Assembly. Install new Ice Maker Assembly, plug in new wire harness & screw harness cover back on.

Replaced Water Filter (twist off old filter; twist on new.)

Simply twisted off the old water filter, unwrapped the new one and twisted it on.

easy easy easy!!!!!

after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell

replaced the filter with the new one i purchased

replaced door and window. Snapped in place

pushed new spring in.

Very simple, I followed instructions sent with the filter. Twisted old filter clockwise 1/4 turn to remove. Filled new filter with water, lined up arrow on filter to arrow on refrigerator, and then turned 1/4 turn counterclockwise. Filter raised and seated itself. Wiped few drops of water from refrigerator shelf.

Installed new spring pin and spring. Took only 2-3 minutes. It was more difficult to get the correct part since the spring pin was the only number listed in the part diagram and I actually needed the spring and had to call customer service to get the correct part number.

I had to remove the clear plastic from the old part and install it on the new frame. I put the plastic in first and could have easily broken a pin. There should be a recommendation to put the frame in when it can bend a little and reduce the chance of breakage again. Put the clear plastic piece back in after the frame is in. That would have been much easier.

I removed the vegetable bins as well as the side panels holding the flip panel. I then tilted the left panel and slipped the side pins in their respective holes. This took some time as it was difficult getting the housing under the drawers to fit back into the side ledges. I was ready to call for a repair serviceman but was proud when the job was completed.