MHE10RXB0 Roper Microwave - Instructions

Third time I had to do it. For some reason the handle breaks on this model. The unit is 16 year old. It was one of the first over oven microwaves (built in)ever made. Just remove cover panel with a bread knife. Then use a phillips screw driver and your done. Put the cover panel back on and this microwave has been a work-horse for the past 16 years and still ticking.

Watched a you tube video prior to installing new switch. Followed the video which gave me confidence i was up to the task. After removing the touch pad I found my design was not exactly like the you tube model but I found the defective switch, replaced it and put the microwave back together. Works great. Again watch the videos

Unscrewed glass panel, removed old bulb, cleaned glass panel and installed new bulb. Screwed panel back into place.

Found correct part number, ordered, then installed.
Ordering was quick and easy. Delivery of shelf was very fast.
Very satisfied with everything.

Simple slide the tray into the groove

All the electrics worked on Amana microwave EXCEPT for the cooking function. Inspected the control board and found the upper switch on the door interlock was burnt. Installed new switch in minutes and everything now works fine. Unfortunately, had to purchase expensive two switch "kit" although only one switch was kaput. PartsSelect mailing was SUPER fast. Thanks for looking, Scott

remove 4 screws from top, front louvered panel snaps out. remove 1 screw from top of keypad, keypad pivot's forward and can be removed. There is a white mounting bracket inside left. Remove two screws, one top and one bottom, bracket lifts up and out. 3 sets wires are attached, mark them with masking tape, top, center, bottom and pull out plugs. They can only attach one way. Using a very small screw tip, lift plastic latch from switch, it rotates out and is removed from the pivot pin. reassemble in reverse order after switches are replaced

Removed one screw lowered glass cover removed burned out bulb replaced with new one put glass back reinstalled screw. Dune 5 minutes back in business

Open compartment, installed bulb, closed compartment

Popped out the two little plugs, unscrewed the broken bits and left the screws in the door...after reading someone else's feedback about the door being hollow and dropping the screws I thought this was the better part of valor....screwed the handle back on, popped the strip in place and presto change-o it was fixed. Easy as pie!

Replaced light bulb.

removed grill cover, removed bulb plate, unscrew bulb, screw new bulb in socket,put bulb cover back on and screw grill cover back on. no issues whatsoever.

Unscrewed the broken handle, and screwed on the new one. My new handle arrived one day after placing my order.

I took the plastic caps off the door to reveal the screw heads (Phillips) pushed on the screws to push the handle out of the door. then with the screw driver and a skinny object (pencil) I pushed the screw out with the screw driver and pencil so I would not lose the screw in the hollow door. we were using the door in the mean time waiting for the handle to come. if you were not there would be no reason the take the screws out. install the new handle being careful not to push the screws out of the hole and snug them up. just tight enough to keep handle from moving so as not to crack the plastic handle. snap the cover on with a little supper glue, done. very easy swap.

unscrewed the 2 broken ends, one at a time, careful not to let the screws drop inside the door. (keep inward pressure on the screw) Attached each end with the same screws. Completed in less than 5 minutes