MH1150XMB0 Whirlpool Microwave - Instructions

The most difficult part was getting the old screw out of the top of the grille. Once that was accomplished, the rest was easy as can be. I would highly recommend your service - very good! Thank you!

My vent grill fer me microwave done and fell off.

The part came very quick less than a week. The installation took less than 15 minutes.

Easy to do. Remove the old screws where the tabs had been broken off. Install new vent and replace screws. MAKE SURE THE TABS ON THE BOTTOM ARE IN THE SLOTS.

Took out the turntable parts to ensure I ordered the correct cooking tray. Matching those with photos of related parts on PartSelect worked great. Put turntable drive and support ring in place and cooking tray went in very easily. Plan to order a second one to have on hand for this rental property.

Ordered the glass tray and installed it. Received the orderin about two days.

Removed retaining screws and broken parts; inserted new grill and screws. Fin!

removed old vent and replaced by snapping in and two screws inserted into right and left top connections.

PartSelect was the only company to show that the part came in 3 different colors. The grill vent was used to replace a cracked vent. It was simmple to slip in the new vent,but be sure to save the existing screws that holds the vent in place

Placed to new grille on the microwave and attached
with the screws.

Replaced the missing tray and unscrewed a couple of screws to remove broken grille tabs and retightened the screws to hold in the new grille. Very successful and very easy. Thanks

This is a very basic job that a ten-year-old can do. Simply remove two screws at the top of the unit, remove the broken pieces of grill, snap the new one in place, and replace the screws. Oh, yes, I also cleaned out the foam and aluminum filter and cleaned some of the grease from behind the filter.

rEMOVE FRONT OF DOOR (3 SCREWS ON SIDE), PUTTY KNIFE TO EDGE of dorr to free front of door. Unscrew 2 screws and install new handle.....Keypad: One screw out , lift assmebly up and out; remove old keypad, change tape connrction, replace pad...

replaced with new one

Unscrewed the remaining (2) screws that held the vent in place, placed the new grill in the tab loctators, and screwed it into place. Done...in less than 10 minutes. It took me 15 minutes to find my wife to show her what a nice job I did.