KSB5BK4 KitchenAid Blender - Instructions

Followed the instructions that came with the replacement drive coupler, first removeing the old part using a screw driver, and then easily screwed on the new part. Removing the old part without the aid of the instructions would have been problematic.

Watched the video on the site on how to remove the old one and install the new one and it took me all of 5 minutes, at most. I almost threw it away. Super cheap repair. The product arrived in 2 days too. I am saving the site. They are great.

easier than i anticipated. i thought i would have to tear the unit down to get this part installed, but the replacement came with (even an idiot can do it)instructions, and it took all of four minutes. Mike in Albemarle,NC..

Pretty muched followed the directions, but after reading all the reviews I knew what do to before the part arrived. Super easy. My blender had been out of commission for a while...now I'm back in business. Well worth the $14 (part and shipping).

It was harder than the directions said to get the old drive coupling off, but once the old was taken off, it was a piece of cake to put the new one on.

Thanks, great service from this website, received my part the next day after I ordered it!

Just like the directions said, I pryed up on the coupling at a few points around it's circumference and it became loose enough to unscrew. I didn't believe it was going to work at first but, amazingly, it did. All that was left to do was screw on the new part. No problem!

Using the precise instructions provided by parts select, I used a big screw driver and pried off the old coupler and cleaned the area and screwed on the new coupler. Fixed!

The part finally arrived 3 weeks later, after being out of stock and back ordered a couple times.

Thanks to everyone before me and their stories!
I felt confident enough to try repairing my blender myself ! ! !
I just placed a flat head screw driver under the coupler and pushed up on the screw driver, 3 or 4 more times around the coupler. It broke away and a metal disc was left, which I unscrewed and I just screwed the new coupler on.
Thanks Again!

Followed the directions and used a screwdriver to pry off the old gear. Screwed the new one on - reverse thread. Easy as that.

used thin wire strippers to hold screw shat, than unscrewed one and screwed on the other. done

I unscrewed the old coupling and screwed on the new coupling from Partselect.
This was a personal repair job.
However, I am a local Handyman in Northern NJ that does a ton of minor repairs. For all of my appliance part needs I will buy from Partselect.com. They under promised and over delivered! Just incase you dont know what I mean by that statement,,, I ordered the blender part, they told me I would have it in 6-10 days (which was acceptable to me) and I had it in two days... AWESOME job FOLKS!!!!!!!

Simply followed the online video instructions. Screwdriver to remove the worn out part. Rag to clean threads. Hand tighten replacement part (reverse threads). Blender fully functional. Couldn't have been easier.

Pried the old coupling off and unscrewed the metal piece remaining then screwed the new coupling on.

I repaired it as per instructions provided by using a flat head screwdriver to pry the original off.

Pry off the old, clean up drive threads, thread on the new one. easy as pie