KHMS155LSS1 KitchenAid Microwave - Instructions

I just opened the box and set it in. Took all of two minutes.

My husband just installed the mounting plate on the wall and the microwave was placed in position and mounted in less than 5 minutes.

Problem was easily diagnosed using the internet as a resource, problem was a bad stirrer motor. Hardest part of the repair was the removal of the microwave. Once off the wall, you remove the outer cover and a molded plastic casing directly underneath the outer cover at the top of hte microwave to expose the stirrer motor. Removed two screws and two wires and the old motor is out. Did exactly the opposite to install the new motor. The kit I recvd included among other things the motor, a new inside cover, plastic rivets and even silicone to seal the inside cover. I am sure I saved a couple hundred dollars by doing myself.

Simply placed new dish on the rotating hub.

Taking the door apart was easy once you figured out how it came apart. Youtube videos were not helpful as every brand of microwave is different; what works for one does not work for another. My Kitchenaide has little interior hooks on the inside of the door, 8 on top, 8 on bottom, 4 on the hinge side. You have to pry the door-skin up to get teh hook disengaged, then get a putty knife or similar to keep the hooks from re-engaging. Once you have about 6 or 7 undone, the door starts to come apart. Eventually the exterior of the door comes off; the interior of the door remains hinged. After that, you'll figure it out...

The door ordered was exactly what I needed to replace the old one, however, removing the old door and installing the new one required breaking down the microwave oven. Without the knowledge and tools to accomplish this I had to call a kitchen aid repair service. The labor cost was $160 and considering the complexity of the work it was worth it.

Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.

1. Unplug the power cord from the wall socket. 2. Remove the 10 screws holding the bottom cabinet cover in place. The bottom cabinet cover will swing down allowing acces to the inside ofe the microwave. 3. Remove the connector from the turntable motor. 4. Use a T15 Torx driver to remove the 2 Torx screws holding the motor in place. 5. Remove the motor. 6. Reverse the process using the new motor.

Some difficulty getting screw loosened, once that was done replaced burned out bulb.

Ordered the item on a Monday at 12pm and it arrived the next day. Amazing!

took the light assembly off and replaced the bulb and put the assembly together and fitted back in the space and finished the assembly.

just replaced the filters

Followed the instruction booklet that came with the microwave. Very easy.

Open door remove the 3 screws Gently prior door apart. the outer metal piece with glass comes off easily, unscreew door handle. alignn new3 handle an use the same screew ro attach door handle. Replace outer metal piece the replace 3 screws One tool needed a phillips head

Twas really easy considering that all I had to do was place the plate back in the microwave. Easy Peasey