JEC9530ADS Jenn-Air Cooktop - Instructions

After unit dried I turned top back on and everything worked but right front control and no fan. I disconnected power, removed BX whip at junction box, took top out, flipped over and removed screws around side , lifted up about 4" disconnected fan laid cover back over BX. looked at right front control and saw circuit board and black all around switch area got numbers put together and ordered part. I talked to about 5 other places and didn't have a clue or part was not available. The woman I talked to knew her stuff and asked all the right questions because there was no part names or list other than right front control.

Only hitch I experienced was identifying the correct replacement. The original diagram presented the accurate shape of the element my range required. However a different shaped element was displayed when I noted my unit is a series 12 serial number. I ordered it (with reservations) and as it turned out the replacement was identical to mine. Next time I will have a lil more confidence in the instructions given.

Unplugged the power cord first. Opened oven door and removed the two screws that held the stove top glass down. Lifted the glass top and removed the four wires connected to the element. I taped the wires to the lid in the pattern they were attached to the element. remove the element from the brackets. The new element was an exact match. reversed the sequence. Put a pot of water on and boiled a hot dog! Perfect! Great part and speedy delivery!!

Simply replaced old switch with new one. Was very easy to do.

Simple repair to replace stripped out knob. More importantly we ordered the part over Christmas and it arrived within 2 or 3 days

I actually did it manually. It was fast and easy.

1st - UNPLUGGED appliance from electrical source!! then removed screws to open ceramic stove top, disconnected wires from dead element, plugged in wires to new element, closed stove top, turned on burner - it worked!!

only problem is that "hot burner indicator" does NOT stay lit after burner is turned off!

To be honest, it was nothing much. Had to reach and remove metal collars that were left behind around the pins, with needle-nose pliers. Put in the new knobs, and we were done.

What really left me impressed was 1) that the rep sent me pictures of the suspected knobs over email so I could identify them easily, and 2) I was expecting to wait for a week but I had the parts the next afternoon!!

The hardest part was finding the part number...and that wasn't all that bad. Perfect match; perfect fit.

Turned off circuit breaker.Removed cooktop from counter top. Used small knife to break silicon seal. Removed glass top from pan by removing retaining screws.The removal of the old part required removal of a nut on the switch shaft which was not obvious . This required the needle nose . Otherwise the replacement was simply exchangeing the wires.

parts came on time and the repair was just remove the old and replace with new.

Element was sent by buyer, As they recommended, when model of stove given to them. It was upper right rear. When element came. First took off old element. ...Match both element , new element did not look exactly the same, small variation. It did not come on.. I moved old element from left side to right side . Old element worked on both side .. tried new element on left side also.. still didn't work.. so I called right away and explained.. new element did not work.. not defective, but, just wasn't the right one.. I had a specialist came and check it out also. I was told wrong element.

Remove old knobs and remove old grommets. Insert new grommets, install new knobs.

Removed old knobs. Removed the metal insert from around the post from the old knobs with needle nose pliers. Installed new knobs. Easy fix.

remove old knob, plce new knob on.