GZ2727GEHB Maytag Refrigerator - Instructions

piece of cake . removed the cover - one screw in the switch and back together again - maybe 10 minutes.

looked a website removed part found broken item order and installed in 15 minutes, easy simple fix very low cost change

rl

Ordered part and plugged it in. Simple! It fit perfectly

just snapped the new one in. I am very happy. the part was delivered in just a few days--I was surprised how quickly it was delivered. thank you. I would use your company again.

installed new parts

Remove the broken part and disconnect the plug for the motor for the ice dispenser. Then I cut a hole large enough to insert the motor prongs in the new part. Made two braces to add strength where I cut and reinstalled the motor . I was not able to disengage the prongs and didn't want to brake it. Works fine. The part came in one day. Great work Parts Select!!

Ordered the parts, snapped them into place on the basket and then slid the arms into the holes on the freezer door, very very simple..

The best part of the repair was how easy it was to find and order the part. Instead of searching the parts houses around town I just went to the PartSelect web site, quickly found and ordered the part in about five minutes, received the part the next day at my home and was ready to make the repair. Wow! What a pleasure for something to work the way it was meant to. Removed old switch located by prying out with sharp knife or screwdriver. Don't worry about breaking it or cracking plastic. Disconnect(unplug) wires from back of switch. Replace (plug-in) wires on back of new switch. Insert in location of old switch. Finisheed.

Took out lower shelf. Unscrewed screws holding two broken shelf supports and removed broken supports. Replaced with new supports and screwed in the screws. Nothing to it.

have always done it myself, but Maytag store closed, so I didn't know where to purchase filter

I received it from Parts Select, in 2 days and if I remember right, price was cheaper than I paid last year, at store.

The most time-consuming part was removing the screws. First, remove the 8 screws that attaches the ice bin to the front cover. This will free up the auger enough to pull up the back end where the drive ring is held in place. The ring just pops right out. The only thing I recommend is as long as you have the bin out (and empty), go ahead and give it a good wash. Make sure it is thoroughly dry so that no ice freezes to the moving parts.

replaced the broken basket stop with new one. took a whole minute to do so!!!!!

Repair requires the removal of the bottom hinges on the doors. No problem for the refrigerator side, but the freezer side has wiring in the freezer door for the water/ice dispenser, so have some wood blocks handy to prop it up. Biggest challenge is that in the center of the kickplate there is a mounting screw (Torx head) that is behind the kickplate and runs vertically. I removed the old kickplate without removing this screw, just broke the kickplate off. The screw is very difficult to access with any tool. Removal wasn't too terrible because the old kickplate was gone; but insertion with the new kickplate in place was a challenge. I used a Torx socket, but because there isn't enough clearance for the ratchet, I held the socket into place by wedging a large flat blade screwdriver between the bottom of the socket and the floor. I was just able to get my index finger under the new kickplate to slowly turn the socket to fasten the screw. Unfortunately I didn't feel as though I could skip the screw - without it the kickplate sags in the center.

unscrewed all the electric componets from the broken enclosure and screwed them to the new one and reenstalled. we got the new enclosure faster than expected will probably use part select again when needed.

Poped ou the old switch, connected new switch and pushed back into socket.