GLMV169DBC Frigidaire Microwave - Instructions

on the inside of the door we gently pried off the liner to get ot the hinges ,lifted off the old door, place the new one on ,then carefully popped the inside liner back in place. Door fixed

I used a medium sized flat screwdriver to insert between the upper door hinge pin and the microwave hinge bracket. I applied prying pressure by twisting on the screwdriver and the door fell off. Recommend making sure you have a good hold of the door - It almost got my toes. Installation of new door was a little more concerning with the thought of damaging my new door. I placed the lower door hinge pin into the lower bracket. Placing the upper hinge into position for prying. I recognized it was going to be a tight fit. I used the screwdriver in the same way as take off. I struggled a few times with thoughts of cracking the plastic on my new door, but finally pried enough to get the pin in the hole. The plastic around the inner door popped out of place around the hinge, but snapped back in without damage. A fairly simple project that got my heart throbbing a few times with thoughts of damage control, but all is well that ends well.

Slid old one out and slid new one in (under tabs).

The old door came off easy quick. the new door was a little different. I used a flat head screw driver, popped the bottom hinge in first and I did the same on the top. The top you had to use more pressure and use a little more force to rotate the hinge to the pin hole.

OK folks. Take a butter knife and pry the top and pop off the bottom. Literally less than 2 minutes! Simple. Fast. Easy. Fit perfect!

After trying to bend parts that do not bend I realized you need to remove the plastic gasket around perimeter of microwave door but leave it loosely hanging on (pry off with screwdriver) With the gasket removed you can fit the door on and the snap the gasket back in place before closing and testing. The door was a perfect fit, it works great. The door will not go on until you remove or bend back that gasket. It's not obvious how or where to remove but just put a screwdriver in there and you'll feel it pop out and it snaps right back in after assembly..