GFSS6PKBASS General Electric Refrigerator - Instructions

removed the clear window and replaced the window into the new pantry cover

Pulled one out. Put new one in.

replaced lights in refrigirator and freezer

0. As a safety precaution, unplug the range or hit the relevant fuse breaker before you start. You might also want to grab a flashlight. Definitely do not try to do this while the oven is hot.
1. Pinch the wire over the light bulb cap to remove it. This is inside the oven at the back.
2. Pop off the hemispherical glass cap.
3. Unscrew the old light bulb, and screw the new light bulb in its place.
4. Put the cap back.
5. Secure the cap by putting the wire back in its slots on the cap.

No tools needed, the cap is just held in place with pressure from the wire.

Replacement ice maker was plug in unit, only needed to remove one screw holding plastic plate that hid plug and wiring. Plugged it in and reattached plate with screw and done!

Moved stuff out of my way on the top shelf, reached in and turned old filter to remove. Filled new filter with water, lined up and turned to lock in place. Whew, never thought I would get that job done. :-)

Hardest part of repair was getting frig. away from cabinets to unplug it.
Turn off water to ice maker.
Phillips's screwdriver to take off the cover of the electrical connection to
the icemaker tip it outward. I used flat head screwdriver to help disconnect the connection.
Also, to help getting the old icemaker removed. Once removed returned New one the reverse of taking it out. Won't need screwdriver to get it back in place. Put cover back in place and put the Phillips screw back in place. Plug refrig. back in. put it back in place turn the water back on should be good to go! BE afew hrs. before ice starts to show up!
Good Luck

Remove a couple screws unplug part. Plug new part in and replace screws.

I only had to remove the old filter and install the new one - all by hand. I then ran about 1 to 1and1/2 gallons of water through the filter to clear it.
A WORD OF CAUTION - HOLD YOUR GLASS CLOSE TO THE WATER DISPENSER FOR THE INITIAL FILLING - IT WILL SPIT UNTIL THE AIR IS PURGED FROM THE SYSTEM!!!
An extremely easy repair.

Take top two drawers out and install the flip up cover in it's spot , then use the screw driver and pry it flip cover, into the groove.

Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.

Water flow restrictions. Replaced flow valve. No help. Checked again and found filter head flow stopping valve broken. Replaced same. All good.

Took the old filter out and put the new one in.
Easy Breezy!!

Unscrewed old cartridge, ordered new cartridge, installed new cartridge by following very simple instructions. Took only one day for part to arrive from PartSelect although I paid for cheapest shipping, which was "ground." I was amazed!

got new filter