GFSS6PKBASS General Electric Refrigerator - Instructions

Installed new spring pin and spring. Took only 2-3 minutes. It was more difficult to get the correct part since the spring pin was the only number listed in the part diagram and I actually needed the spring and had to call customer service to get the correct part number.

I had to remove the clear plastic from the old part and install it on the new frame. I put the plastic in first and could have easily broken a pin. There should be a recommendation to put the frame in when it can bend a little and reduce the chance of breakage again. Put the clear plastic piece back in after the frame is in. That would have been much easier.

Very simple, I followed instructions sent with the filter. Twisted old filter clockwise 1/4 turn to remove. Filled new filter with water, lined up arrow on filter to arrow on refrigerator, and then turned 1/4 turn counterclockwise. Filter raised and seated itself. Wiped few drops of water from refrigerator shelf.

unscrew filter and replace the new one

Very easy ,new unit has rollers instead of all plastic sides,just pop- it in, now works better than original.

Removed the old filter. Filled the new one with water and put it in theplace of an old one. Flushed the system with 1 gallon of water.

Very easy, unscrew and re-screw new filter in..

I removed the vegetable bins as well as the side panels holding the flip panel. I then tilted the left panel and slipped the side pins in their respective holes. This took some time as it was difficult getting the housing under the drawers to fit back into the side ledges. I was ready to call for a repair serviceman but was proud when the job was completed.

Appreciated others comments before I had to repair mine! Took me a bit to get clear part out of white frame (with screwdriver). Popped clear part into new white frame, but then had to push on some parts to really get it to snap fully in. Then it was simple to put the one pin into the hole on the fridge and bend the frame slightly for the other pin to go in. Thrilled to have it look great and work correctly.