BX521VCPSR (P1325030W S) Amana Refrigerator - Instructions

Needed ice maker bucket for extra fridge. Part came the next day, and worked perfectly.

I took out the old one and put in the new one. For some reason the repair story associated with the ice bucket had nothing to do with ice buckets.

I simply put the post in and set up the drawers and shelf.

First I couldn't get it back..due to eye problems so i gave it to my husband and he just did it in a flash..you set it under the glass and put the drawers or crispers back in and its done.

Attached the retaining clips, and popped it on the
refrigerator. End of story.

Remove shelf assembly containing meat drawer. Remove drawer. Remove rollers and reinstall on new glides. Reassemble drawer unit and put back in fridge.

There was three screws to remove to unmout the ice maker, and unplug the wire harness,then two to remove to slip in new stripper. All took about 20 mins.

bulbs were not burnt out. received the new switch in a few days. watch the short video, was good to see how it comes out. used a putty knife to release the defective switch, removed wires put them on the new one and posed the new switch back in. Not bad Part cost $11.00 7 dollars shipping so for 17 bucks it works great. nice to see what is inside the refer!

We looked up the problem online with the model number of the refrigerator. We ordered the part and followed the video installation that was sent with the order and was found online prior to purchasing

Eased the putty knife under the edge of the switch housing and pried it off. Pulled two wires off the old terminals and hooked them onto the new one and reinstalled into the refrigerator body.

removed crisper drawers, then food items from shelf above, then replaced support post and replaced drawers and food items from shelf

I was able to lay the gasket out flat for about a week. Then installed after removing the old one and the inner part of the door. Getting the small flap that goes behind the edge of the inner door and keeping it in place while reinserting the screws around the edge was the most difficult. It might have been easier wit a magnetic nut driver to start the screws as it was difficult to start the screws when they kept falling.
The gasket fit great and it is a good do it yourself project that will save a lot of money

Lifted both drawer runners removed the broken post, put new post in place. Job completed in lest than two min.

At first I went to a local part supplier and they didn't have it in stock but could order it for me for $55.00 plus $10.00 to ship it. I told them I would have to think about it. I went home and got on the computer and found your web site and was I shocked when I saw the same part listed for $6.98 and $7.00 to ship it. You guys saved me $50.00. The part arrived in two day and took 5 min. to install. I now have light in my refrigerator. Thank you.

Part was easy to order, delivered quickly, installation very easy. Just unplug the unit, pop out the old swich using a screwdriver, disconnect and reconnect leads and pop switch back in. Definitely recommend that you can do it too.