AS2125CIHW Maytag Refrigerator - Instructions

I couldn't have repaired the refridgerator at all if your web site didn't have photos along side of the parts. My parts no. was destroyed. But after removing the face plate on the ice dispenser door and checking the area behind the plate, the burned part was clearly identifiable. I removed the one screw holding it and the two connecting wires - and pulled out the tiny switch. On your site, I entered the refridgerator number, and the parts list (300 or so parts for this model) appeared with identifying photos of each part. All it took was to order the part (and the ice door simply because it was old) and put it in when it arrived in one day! No only did I save much cash, but I left with the confidence that I knew what went wrong. It works as good as new now. Thanks!!!!!

There was three screws to remove to unmout the ice maker, and unplug the wire harness,then two to remove to slip in new stripper. All took about 20 mins.

took off the covers and put in the new part and then put it back together.

Removed 2 screws for front cover lifted front cover straight up to remove.Removed 2 more screws to remove ice door assembly, replaced ice door. Refrigerator should be unpluged before doing any of this to avoid getting shocked.

I removed the screws that held the control panel in place. Unplugged the wiring cable and put the control panel aside. I removed the old broken part and inserted the new part. Very easy. Put everything back together and it worked like new.

Pried out the old switch and installed the new switch.

follow video

bulbs were not burnt out. received the new switch in a few days. watch the short video, was good to see how it comes out. used a putty knife to release the defective switch, removed wires put them on the new one and posed the new switch back in. Not bad Part cost $11.00 7 dollars shipping so for 17 bucks it works great. nice to see what is inside the refer!

Had to push the light switch to get lamp to light up.
Removed power from refrig. and removed old light switch
and replaced with the one I got from Partselect. Turned power back on and was done.

First I removed the three screws in the top hinge that hold the upper right corner of the door to the body of the unit. Then I just lifted the door off of the refrigerator. I proped the door up just long enough to pull out the old pin (plastic) and put the new one in place. Next I picked up the door and set it on the new hinge, and last I put the three screws back into place. It has taken me about as long to type this out as it did to actually make the repair. The part was also very reasonably priced so I purchased two since this items has been replaced previously.

Unplugged the refrigerater from the outlet. Took off the front ice and water dispenser assembly. Disconnected the front panel from the electronic board. Removed the ice and water dispensing cone and installed the plastic/Foam insulator door between the two plastic arm frames.

looked a website removed part found broken item order and installed in 15 minutes, easy simple fix very low cost change

rl

piece of cake . removed the cover - one screw in the switch and back together again - maybe 10 minutes.

Repair was tremendously easy. All I did was remove old light switch by prying out with screw driver and plugging in the new light switch and pushing it into the hole. Simple! The instructions weren't needed, but they were very thorough.

remove the screw on the front panel---

remove old part --- snap the new piece in

replace screw