All Installation Instructions for Kenmore Range 79061130102

rear drawer glide broke

The repair was as simple as reattaching the broken glider. No tools were needed.

Parts Used:

Barbara from Concord, CA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Broken Drawer Slide

I watched the repair tutorial and followed the instructions. The order went very well and the tutorial was spot-on. Nice.

Parts Used:

Rear Drawer Glide

Richard from Woodruff, WI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

burner was not heating properly

I ordered the element. When it arrived, I simply removed the old one and put in the new one. However, it did not completely solve the problem. The heat is now distributed evenly, but still have to turn the burner to 7.5 to boil water.

Parts Used:

Surface Element - 8 Inch - 2600W

Marilyn from Dasssel, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Drawer would not stay level or move easily

The drawer dropped down and would not easily open or shut or fit up good when closed. A quick inspection showed that one of the rear drawer guides was broken. The parts were ordered on a weekend and they showed up on Tuesday. We already had the pots and pans out of the drawer. It took about 10 minutes to put in the new guides (I replaced the one not broken also), clean and lubricate the drawer slides. Good as new. The repair video, although not necessary for this repair, was excellent. Thanks a bunch!

Parts Used:

Rear Drawer Glide

Kenneth from Ovilla, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

My original drip bowls were rusty and ugly on the two front burners.

I removed the old drip bowls from the top of the stove and replaced them with the new ones. I am not a handy person but even I had no problem doing it as I regularly remove them anyway to put them in the dishwasher to clean them.

Parts Used:

6" FM CHROME DRIP B

Drip Bowl - 8"

Margaret from East Point, KY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

55 yr old wall oven had burnt out seal

Very easy--just had to drill new holes for the clips because the are already pre set in the rubber gasket

Parts Used:

Oven Door Seal with Clips

Diane from Natrona Heights, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

rear guide clips were broken

This was the easiest do it yourself repair job to be had so simple just push the new clip in the hole and you are done so easy. Audrey

Parts Used:

Rear Drawer Glide

Audrey from Miami, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Gasket In Door Replaced

The gasket just snapped in place. The first one I ordered was, my fault, the wrong one and I returned it and got the correct one two days later.

Parts Used:

Oven Door Seal with Clips

James from Greenville, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

the pullout drawer below oven did not work

the rear glides were missing on the back of the drawer so the drawer would pull out but when pulled back in, would tip down and not catch on anything. I ordered the parts then found an instructional youtube and watched it. Easy repair, cheap!

Parts Used:

Rear Drawer Glide

Dawn from Palmer, AK
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

broken drawer glide

I am a total non repairman. but with the video on how to I did'nt even brake the first part. ( I ordered 2 just in case)Will use you ror every part!

Parts Used:

Rear Drawer Glide

tom from duluth, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Burner heating element would not sit level with generic drip bowls

I replaced the generic drip bowls with the ones I ordered here and the work perfectly. The heating elements now sit level and I am very happy with them. Very easy to replace.

Parts Used:

6" FM CHROME DRIP B

Drip Bowl - 8"

Cheryl K from Klamath FAlls, OR
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Replaced burner block

Looked at the instructions and cut the wires, put the new wires in the block, attached the block to the range, put the new wires to the range wires using the wire nuts. I plugged the element into the block turned on the power, tried the element and it worked. It was really a easy repair.

Parts Used:

Terminal Block Kit

Glenn from Fossil, OR
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

heating element didn't work

I did the repair in less then 5 minutes. I took out old element and put in new one and turned it on and I had heat. Works great Thanks the part came in 2 days what a wonderful suprise that was.

Parts Used:

6-Inch Coil Burner Element

Judith from Sidney, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

rear drawer glide/problem was when wife saw video

It took about 3 years to order and 3 minutes to fix. forgot to turn off "easy" video on conputor. Wife watched was mad........... for taking so long to fix. 41 years married, any video to fix wife and get me to 42 years as easy as changing draw glides? Thanks Jon

Parts Used:

Rear Drawer Glide