66562614201 Kenmore Microwave - Instructions

took old vent grill and tabs off using phillip screwdriver. started putting new grill on and it wouldnt go on. got to looking and there are two more screws that you have to loosen up so the grill will go into place these two screws are between the two tabs at each end. caution do not over tighten the screws it will break the tabs. overall easy to install.

Replaced vent with 2 screws. Very easy.

Removed one screw lowered glass cover removed burned out bulb replaced with new one put glass back reinstalled screw. Dune 5 minutes back in business

Removed the screws holding the broken tabs and thought the new vent grille would click right into place. I had quite a bit of trouble getting all the tabs lined up to click into place, but was finally able to do it. Then I just used the old screws to secure the new grille.

Glass plate arrived in less than two days. Placed the glass plate in Microwave and presto the microwave works like a charm.

submitted manufacturer info to website and voila! a new glass turntable arrived in 2 days. I don't do well with computers, my 23 yr. old daughter was impressed......couldn't be easier! thanx! will definitely revisit your site

Removed screws holding tabs from broken vent grill to microwave frame.

Carefully snapped new grill vent into slots on top of microwave and slid tabs into slots on top of the frame.

Replaced the two screws in the tabs.

Finished

Unscrewed the remaining (2) screws that held the vent in place, placed the new grill in the tab loctators, and screwed it into place. Done...in less than 10 minutes. It took me 15 minutes to find my wife to show her what a nice job I did.

I removed the broken tabs with a screwdriver and snaped in the new cover replacing the screws once I had it in place. the entire job took less than 5 min.

All I had to do was open the microwave door and place the turntable on the designated grooves, wha lah it fit. I am now back in business. Thanks to partselect, I found my replacement, ordered and it was shipped in no time.

Take out the screws, broken pieces of clip, then put in the new vent grill, replace the screws. Done!

Removed the broken parts and screws and placed the new vent on and tightened screws. I am an 76 year old woman, so if I could do this, then anyone can! Surprisingly easy to install.

Just remove the old one, inserted the new grill and tightened the screws on the top of the microwave.

Having the correct model number helps:
Just place the parts in the microwave and it worked.

Unscrewed existing screws, removed old grill, fit new grill into proper slots, reinstalled and tightened screws.