66562614201 Kenmore Microwave - Instructions

First, we had to clean up all the interior surfaces, which was just cleaning. There was no internal damage. Then, just setting the center connector, rotary rollers and glass plate. Simple

Whirlpool Model# MH1150XMS-0 purchased in 2004. I called Whirlpool and they suggested a new microwave. No big surprise - being the thrifty person that I am I wasn’t taking this for an answer. I figured if I had to purchase a new microwave what was $35.22 (part# PS373828 + shipping) if it worked.

I replaced the latch on the microwave door. Once the latch was replaced. I also took this time to make sure that the microwave door was in alignment. Thereafter, I had to adjust the door interlock switch behind the microwave console panel to recognize the microwave being closed. Yes, gaining access to all these areas was a bit difficult but have patience. TADA!!!....microwave is working. #girlsrock

Removed bed two screw replace grill

Ordered a new motor. Removed the outside trim of the oven-microwave combo. 2 screws at the bottom of the trim. Removed the screws that held the combination micro and oven unit in place. Removed the top and bottom black plastic grill of the microwave. 3 screws each. Pulled the entire unit out about 1 inch exposing the screws at each side of the microwave that hold it in place.
Snapped off the top control panel which exposed the wiring connecting the control panel.
Unplugged a couple of wire harness units to free the control panel.
Be sure to label the units to know which goes where during reassembly.
Remove the microwave unit from the housing and place it on its side.
Remove the metal plate that houses the motor. 4 screws hold the motor in place. Disconnect the 2 wires from the old motor and you are ready to install the new motor. Be sure to TURN OFF THE POWER to the unit at the breaker box and remove the turntable from inside the microwave.

The part came very quick less than a week. The installation took less than 15 minutes.

Ordered the glass tray and installed it. Received the orderin about two days.

Removed retaining screws and broken parts; inserted new grill and screws. Fin!

Took out the turntable parts to ensure I ordered the correct cooking tray. Matching those with photos of related parts on PartSelect worked great. Put turntable drive and support ring in place and cooking tray went in very easily. Plan to order a second one to have on hand for this rental property.

Unscrewed glass panel, removed old bulb, cleaned glass panel and installed new bulb. Screwed panel back into place.

PartSelect was the only company to show that the part came in 3 different colors. The grill vent was used to replace a cracked vent. It was simmple to slip in the new vent,but be sure to save the existing screws that holds the vent in place

replaced with new one

This is a very basic job that a ten-year-old can do. Simply remove two screws at the top of the unit, remove the broken pieces of grill, snap the new one in place, and replace the screws. Oh, yes, I also cleaned out the foam and aluminum filter and cleaned some of the grease from behind the filter.

Replaced the missing tray and unscrewed a couple of screws to remove broken grille tabs and retightened the screws to hold in the new grille. Very successful and very easy. Thanks

First, I ordered the part.The part was sent to me within 2 days.Then,I removed the old one that was always falling off and mounted the new one. It was a perfect fit.

I have been doing repair on things on my own for years, I am a retired prevenative maintenace supervisor.
While cleaning the microwave vent grill from being old it fell apart, so I ordered the part using the internet to find the a company that has the same part, the part didnt take long before I recieved it. It didnt take five minutes to install it, and it saved me cash in the pocket from someone else to do the work. wallen