66213293K112 Kenmore Dishwasher - Instructions

Watched instruction video on You Tube. Easy to figure out how old adjuster came off. Followed instructions from video on installation. Did not have proper star screwdriver, but was able to use allen wrench on two screws.

The instructions that were included were a bit scetchy, but we figured it out. I like that the replacement part is made of medal and not plastic. We first put the clips on top then figured out they go below middle bar after that it all came together

Followed the instructions included with the kit, took a little while to figure out what the photos were showing. But essentially installation was easy.

You have to go online and watch a video of how to install the replacement part. Ten or so minutes later you are done.You tube makes everything easier.

The instruction included were pretty comprehensive. Also, it is not a difficult fix. Only thing I did different was install the release arm before snapping the upper part on to the rack. Liked the Phillips screw converter included in case someone does not have star bits for the screws. Returned the stop Clips, not needed.

Followed the pictures not hard at all.

I took the upper rack out set it on its side and followed the instructions that came with the parts. Then turned it on the other side and repeated the instructions. The nice part about the instructions is they they came with clear photographs of each step in the instructions. You could clearly see how the parts were suppose to fit. No guessing at all. Great job, who ever created them. I will not hesitate to but parts from this website and is saved in my favorites.

I read through the instructions which actually took longer than actually doing the repair because some of the pictures were a little dark and it wasn't clear exactly which direction the parts were facing. The repair went exactly as the directions said.

Watched on line video, helped tremendously. The video gave clear concise instructions.

On my kitchen counter! Repair was relatively easy. New adjuster appears to be substantially stronger than old!

Fairly straightforward install of the kit parts. I was glad to see the new parts were stainless steel and not the weak plastic. I wish I would have known this - I ordered two kits instead of one because I figured it would break again soon. I was very glad to finally find the included screwdriver to torx adapter - I forgot my torx set.

Unsnapped old adjusters, new ones went in easy after reading instructions.

Remove old rack adjusters. No removal instructions. Do one at a time. First requires some trial & error until removed. Install new replacement. Instructions not clear because pictures are dark & fuzzy. Again, install one with some trial & error. Second remove & replace becomes very easy.

I disassembled the left side, and installed the new assembly. However, being older and my eyesight not the best, and had assembled it slightly out of position. After adding more light, a magnifying glass. and a much closer look, I found my mistake. I reassembled the unit. The right side only took about ten minutes. I would recommend a larger more visible picture of the unit. I noticed that the units did not roll as easily as the old ones. One must give a slight push to engage the tray into the back of the dishwasher. Had the picture been better, it would have taken only 20 or 30 minutes to assemble.

I had left one adjuster on but the new ones were different. I started great but when doing the top part I didn't line up the wire rack with the holes in the upper adjuster plate and found out it was wrong so I had to use the pliers to unsnap the metal piece where they lock in. Once I got the first one complete it only took about 5 minutes to do the other side. The pictures included with the installation sheet were very dark. A you tube video would have been a great asset. It would have made it very simple and easy. In truth, the second side should only take a minute or two because I was only using one hand. My other arm was in a cast because I broke it. Anyone could do this.