All Installation Instructions for Kenmore Washer Dryer Combo 41761733810

Glide was broken

I watched the video on the repair and followed it. Super easy. Repair only took 30 mins. Please note there are 2 glides. Make sure to order 2.

Parts Used:

Drum Glide - White

Eileen from SHERIDAN, CA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

dryer was squealing loadly

took off face of dryer, removed drum 4 screws removed two srews holding bearing and shaft ,replaced shaft bearing and shaft . Just for preventive maintenance i replaced idleling arm and dryer belt. I lined everything up replaced drum used shop vac to clean lint and dust from all parts replaced face of dryer and boom i got a btand new dryer

Parts Used:

Drum Support Bearing

Dryer Drum Bearing Bracket

Bracket Screw

MIKE from MASSAPEQUA PARK, NY
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Wrench set

1 person found this instruction helpful.

Was this instruction helpful to you?

Noisy

Took it apart and installed the parts. Then I threw the dryer in the trash and bought a new one.

Parts Used:

Rear Drum Bearing Kit

April from CARYVILLE, TN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

the attached anchors and holes linled up about 80% of the time.

I cut off the four that didn't line up - I suppose since this was a gasket that fit several makes, I should expect this type of problem.

Parts Used:

GASKET

Allan D from REDLANDS, CA
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Dryer not heating

Very slowly and carefully, you tube videos and schematic very helpful.

Parts Used:

Control Thermistor

Robert from Olmsted, IL
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Dryer Drum not turning

I found a you tube video that walked me thru the steps. Only problem encountered was 2 screws which were different and a little difficult, but became obvious as the control panel wouldn't loosen as video suggested. Otherwise the repair was fairly easy, and VERY SATISFYING.

Parts Used:

Multi-Rib Drum Belt

John from MOUNTAIN CITY, TN
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Damaged Filter

Took out the damaged lint filter and replaced with new one.

Parts Used:

Dryer Lint Screen

Omar from Rumford, ME
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

LINT FILTER

JUST DROP IT IN WOOOOLA

Parts Used:

Dryer Lint Screen

ANGEL from MIAMI, FL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Squeaking

Watched Video Provided. Very Simple Repair. Asked my lovely wife to hold drum in place while replacing drive belt. She gladly complied and is back doing what she seems to love most. And no, I'm not kidding. Our washer and dryer seem to run 24/7/365. I've completed various repairs on both appliances over the last couple of years and saved 100's of dollars thanks to this site .

Parts Used:

Rear Drum Bearing Kit

David from PORT CLINTON, OH
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Dryer lint filter was all torn up after 12 years of use.

Simple: I ordered the part from you then took out the old old and inserted the new one. Took all of 1 minutes

Parts Used:

Dryer Lint Screen

Michael from DUNN, NC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Just popped the part I ordered right in and it's was closing in no time !

Just opened package and popped the part right in!

Parts Used:

Door Catch

Debra from BROOKLYN, NY
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

old plug would not stay in.

removed old plug which snap out very easy and
snap in new plug.

Parts Used:

PLUG

GERALD from HARRISONBURG, VA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 7 people found this instruction helpful.

Was this instruction helpful to you?

strike broken

popped in one in

Parts Used:

Door Strike

Linda from Batesburg, SC
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

7 of 19 people found this instruction helpful.

Was this instruction helpful to you?

Top hinge on clothes dryer separated, leaving door difficult to open/close

Ordered part from partselect.com. Part was back ordered; however they were very proactive in communicating status updates! When it arrived it was simply a matter of removing door using a philips screwdriver, installing the new hinge and presto - job complete! Kudos to partselect.com ??

Parts Used: