22314 (1988) Kenmore Range - Instructions

easy enough. Before you start, draw a picture of where the wires go on the old switch ( or take a picture).

switch power supply off at breaker panel

unscrew control box assembly from stove

slide control out of stove

unscrew burner control out of assembly

transfer wiring from old control to new in same relative location

reassemble in reverse order

restore power

test burner in all positions

Remove 4 screws that holds down panel;removed dial;removed screw that held switch to panel. Took off wire one at a time ann put on corresponding lug. Repeated above in reverse.

Replaced the control.

To repair, I just pulled out the one unit and replaced with the new. Took longer to get the unit out of the box. We are greatly pleased. Ordered on Thursday and had the unit by Saturday. Saved over $100.00, WILL shop PartSelect again.

I decided to remove the original Jenn Air grill from my stove top and replace it with a new Jenn Air radiant Element Cartridge. I searched on Google for 'Jenn Air radiant top' and immediately found just the item on the PartSelect.com website. I placed the internet order that day and two days later -- kaboom - the part has arrived. I pluggedd it into the stove top (no tools needed) and it was better than new. Wow, that's what I call a great experience! Thanks PartSelect. - Sandi Phillips

Unpacked the new cooktop, plugged the module into the outlet. Done.

Opened the back of the cooktop and found upper right element control switch burned. I removed the retaining screws and wires and spent two weeks chasing the switch at a local dealer. Found exactly what I needed at PartSelect.com and paid less even with shipping than at the local. Installed the switch with original screws and presto!! it worked.

It was easy enough I unplugged the stove. removed the screws under the control panel,removed the panel, removed the two screws holding the switch in place. moved the electrical wires from the old switch and placed them on the new switch. put it all back together in the reverse order.
it took greater than 15 minutes as this is the first time I did any work on my stove and wanted to be careful and not dismantle too much or scratch anything.

Just plugged it in

Looked up schematic. Removed 3 screws holding cover. after I shut power off of course. Took off knob. Oriented new control to the one on panel. Disconnected each wire one at at time and immediately attached it to the new control for each wire. Removed screws holding old control and inserted and screwed to the new control and put the knob back on. Put the cover back on. Worked fine. Probably should replace the others as they don't turn as easily as the new one. Probably will spray some contact cleaner which will give me a few more years.

I took them out of the box, Took the old Elements out and put the new ones in, It was a piece of Cake, You have wonderful girl working for you, she was just great. thanks for the good service. my range looks like a new now. Nora

Repair was very easy for anyone to do,Just lift the old element cartridge up and pull out,And insert new the one! Very simple it took less than two minutes.The New element cartridge(stainless steel) Fits perfectly and functions perfectly.Ordered parts on a Saturday and they arrived Monday! impressive!!

Opened packaged slid new element into place and turned on. End of that job. Cooked dinner.

Take cartridge out of box, slide into slot, done.