22310 (1988) Kenmore Range - Instructions

Opened oven door, took four screws out of the front control panel, removed the two screws holding the burner control switch to the front panel, removed the wires from the old switch one at a time and installed them on the new switch. secured the new switch to the front panel, put the four screws back into the front panel, and closed the oven door. Real easy repair.

Remarkably easy. We had purchased a Jenn-Air with 2 burners and a grill. We found we rarely used the grill feature. We needed more burners. We looked several years ago but it was quite expensive to replace so we suffered through it. I decided I had to find the replacement part or purchase a new stove. I found your website and was shocked to see you carried what I needed. The new part was half as much as we previously priced it for. So, we ordered it and it worked immediately. Thank you so much. Saved me from buying a new stove. Linda

My old burners pluged in. I pulled out the old burners unpacked the the new burners pluged them in. I turned on the new burners and tested themand they worked!!

just plugged it into the unit

Took out of box and plugged into slot.....even I was capable of doing this....easy

Took less than 15 mins to remove the old switch and replace for the new one.
Works like new!

Un screwed the two screws in the downdraft section enough to release the unit that holds the surface burner controls.Then removed the control nob, unscrewed the two screws that holds the switch in the unit, removed the wires, making sure the color of the wires were placed on the same contact point. Put it back together and it worked
fine.Of course I did shut off the power before starting any of the above

I think Part Select is great, but my story? I just plugged in a module.

It was so easy...well...a technical writer--one of those people who writes operation manuals--could have done it. But afterward, they wouldn't have been able to explain to anyone other than another tech writer how it was done.

Just unplugged the old cartridge and plugged in the new one. It took 2 seconds.

Pulled out old cartridges and installed new. Very easy and they work perfectly.
I was very happy with the extremely timely receipt of my purchase which was overnight. I paid for standard 3-5 day delivery.
This was a wonderful experience and I thank you again for your help.

simply remove and replace th switches using a screw driver an a pair of needle nose pliers

Disable cicuit! remove 2 screws on control housing, lift housing. Remove retaining washers from mounting posts (a trifle difficult, but drill into them with an 1/8" bit...they'll break off enough to grab with needlenose pliers). Mount & wire new switch. The replacement retaining washers are too small...hold them in visegrips & ream the hole with a larger drill bit. Place washer in a magnetic hex drive bit, align over post & tap with hammer to start them, then use a small socket to tap them home. Screw down control housing. Enable circuit...voila!

Easily removed the housing - difficult part was removing old fasteners from posts - took 20 minutes caerfully using knive, needle nose pliers, screw driver. Used old fasteners - new ones provided were too small for posts.

I first thought it was the switch. I ordered one and the wrong one was shipped to me FROM ANOTHER COMPANY. After more trouble shooting I discovered it was the cartridge that needed to be replaces. I ordered one and again, the wrong one was shipped to me. They told me I could not get the right part because they were not made anymore.

So, I shipped it back and got in touch with Part Select. They found the right part and shipped it to me in 2 days. Problem fixed with the EXACT right part. I ordered the first part more than two months prior to receiving the correct part from PartSelect. All I had to do was plug it in to the recepticle in the stove. No tools required.

Just slipped the part into the electric outlet