All Installation Instructions for Kenmore Refrigerator 1068480110

Two of the parts were broken so the shelf was laying on the drawers so neither could be used effectivly

Pulled out the stud with a wire cutter and replaced it with the exact part you shipped in the kit.

The other 2 parts just slipped on the brackets

Nice thing is now I have extra parts for the other shelf.

Parts Used:

Shelf Stud

ROD from LINCOLN, NE
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Broken shelf supports

Took just a few moments to install. The parts fit like a glove,

Parts Used:

Shelf Stud

Bob from Las Vegas, NV
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

the front wheel broke

First I had to tilt the refrigerator on wood on the supports under the refrigerator, the wheels were easy to get to then I unscrewed the old ones and replaced them with the new better wheels. The old ones where plastic.

Parts Used:

Refrigerator Front Roller Kit

Mary from Pelham, NY
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

broken light switch

Figured out You have to pop off the cocer than remove the 1/4 hex head screws only not the philips ones

Parts Used:

Door Light Switch

Atlee from Jupiter, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Broken Kickplate Support Clip (Left side)

Unscrewed old broken part from the kickplate and attempted to install the new clip. Mounting screws would not go into the new clip. Had to drill out the mounting holes in the plastic clip using a #30 drill bit. Once the new clip was mounted, attempted to snap the kickplate back in place. Unfortunately at the left side the kickplate would not fully mate with the metal clip on the refrigerator body and would not snap all the way back to the refrigerator front surface, as the right side does. At least the kickplate doesn't fall down onto the floor on the left side as it did before. I suspect there is an alignment problem with the left side refrigerator metal clip, but have not pursued that yet.

Parts Used:

Refrigerator Kickplate Support Clip

William from Fountain Valley, CA
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

After Hurricane Irene refrigeration compressore did not start

Followed the directions. Installation was quick. Took loner to put the covers back on and push the applicance back in position than the repair.

Parts Used:

Compressor Relay and Overload Kit

Bobby from New Bern, NC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

1 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Broken wheel under fridge

Replaced both since they came as a set. The only way it could have been any easier is if I had the wife do it. She had the remote this time. (•¿•)

Parts Used:

Refrigerator Front Roller Kit

Ted from Magnolia, TX
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Refridger will not run unless tapping the control switch.

It was pretty straight forward after all the control panel removed. The plastic tubing was removed from old and installed on new part. Reconnected the connectors and re-route wire to the back vent. After installed covers and control panel, turn on power, it runs.

Parts Used:

Refrigerator Thermostat Assembly

Victor from Colton, CA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

fridge kept running longer an was freezing

took front knobs off an then cover took side cover off next then disconnected themostat and replaced with new and followed the coil to side to the back of fridge an put back together. Oh by the way I unplugged the fridge first

Parts Used:

Refrigerator Thermostat Assembly

david j from monroe, MI
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

you have to turn it off and on to run.

Just like the video showed me.It still does not work. Have to turn it off and on to make it start up.I also replaced thermostat in freezer. Does not work.

Parts Used:

Refrigerator Capacitor

chris from woodland hills, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Freezer shelf falling off

One of the front studs was broken off. I had to use pliers to pull it out (kind of tight). Then I inserted the back and front holders and layed the shelf back in. Total time...10 min

Parts Used:

Shelf Stud

Carl from Crete, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

1 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Broken bracket

Replaced broken shelf bracket

Parts Used:

Shelf Stud

Raymond from Victorville, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 4 people found this instruction helpful.

Was this instruction helpful to you?

refriderator not running all the time

followed directions given on your video

Parts Used:

Refrigerator Thermostat Assembly

beverly beverly from north easton, MA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Both outside door handles turned very beige

Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discoloring refer handles. Thank you

Parts Used: