All Installation Instructions for Kenmore Refrigerator 10641153210

The edges of the Meat pan slide were broken.

I removed the glides under the edges of the meat pan, remove the old pan, put the new pan in and replaced the glides. I was very pleased with PartSelect. I ordered my part, and it arrived the very next day. I will definitely order my next replacement part thru PartSelect.

Parts Used:

Refrigerator Crisper Drawer With Handle

Michael from Bakersfield, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

15 of 18 people found this instruction helpful.

Was this instruction helpful to you?

Freezer light out and refrigerator lights dim

I was not able to unplug the refrigerator because it is housed in a built-in. I removed the icemaker and following simple instructions from YouTube was able to pry the cover off the existing part. After a few gentle tugs, I disconnected the pinned wires from the old part. Connecting the new part was a little tricky but I managed with a little contorting. As soon as the pins connected the freezer light as well as the refrig lights came on. It took about 15 minutes to complete.

Parts Used:

LED Light

Barb from RALEIGH, NC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers

14 of 16 people found this instruction helpful.

Was this instruction helpful to you?

bad door gasket

watched video. Very easy

Parts Used:

Fresh Food Door Gasket

William from Palm Coast, FL
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins

14 of 17 people found this instruction helpful.

Was this instruction helpful to you?

light inside fridge was flickering and clicking

tested bulb good ,replaced door switch first(least expensive)then ordered light socket and circuitboard.If clicking sound is heard replace circuitboard first to save on return shipping because the switch and socket where ok

Parts Used:

Refrigerator Door Switch

bill from escondido, CA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

20 of 35 people found this instruction helpful.

Was this instruction helpful to you?

Cracked Crisper Drawer

This company is WONDERFUL! I ordered the wrong drawer the first time, but their return process was a snap and the correct drawer arrived the next day. It's great to know that there is someone out there with just about every part you'll need for about any appliance that is truly customer friendly.

Parts Used:

Refrigerator Crisper Drawer with Humidity Control

Jennifer from Salvisa, KY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

13 of 15 people found this instruction helpful.

Was this instruction helpful to you?

The refrigerator cannot bring down to the desired temperature

That was due to the evaporator blocked by the ice. Check found the defrost timer is okay. The next thing I can think of is to replace the Electronic Control Board which is installed in the fridge side top compartment. Ply open the face cover, remove the nut and screw that secure the EC Board. Pull out the cable, mount the new card and re-connect. So simple. It is back in order.

Parts Used:

Refrigerator Defrost Control Board

Pit Hoong from Westerville, OH
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

14 of 18 people found this instruction helpful.

Was this instruction helpful to you?

The lights went very dim one day. They are LED and have 4 diodes in each light bar. Three went out for the freezer and one went out in the fridge at the same time.

I tried to replace the light in the fridge first but couldn’t get it out (that one has the control board and is very expensive) so a replaced the one in the freezer by prying it off the ceiling. When I plugged the new one in all the other lights came on full power. Strange but I sent the other one back.

Parts Used:

LED Light

John from KINGSTON, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

12 of 13 people found this instruction helpful.

Was this instruction helpful to you?

Old, cracked freezer door gasket

This is in a rental house; Refrigerator/freezer has been off for a few weeks so just opened the freezer door and used screwdriver to pry out one corner then pliers to grab and pull old gasket (seal) off. Had the new one laid out overnight to relax it; placed one corner on and then the opposite corner then repeated the other two corners. Positioned the keeper edge plastic all of the way around to place the gasket in the door. Closed the door to check the seal and plugged unit back in. Waited and then checked air temp with hand held IR temp gauge. All checked good, no cold spots anywhere. Piece of cake!

Parts Used:

Freezer Door Gasket - White

Ken from ALBANY, OR
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

12 of 13 people found this instruction helpful.

Was this instruction helpful to you?

The led lights on the refrigerator side were dim. The light on the freezer side was out.

I originally ordered the led light control board but when I hooked it up I still had the same problem. My neighbor checked both door switches with a voltmeter and they were both good. I then ordered the light for the freezer and when hooked up the problem was solved. All lights worked. The freezer light has four tabs that allow it to snap into the roof of the freezer. Those tabs can be hard to see because there isn’t much room. I used a mirror to locate the tabs and a small flat tip screwdriver to push the tab over and removed the light.

Parts Used:

LED Light Control Board

Richard from ACCIDENT, MD
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

12 of 14 people found this instruction helpful.

Was this instruction helpful to you?

Refrigerator No Longer Cooling Properly

Approximately:

1. Unplugged refrigerator.
2. Emptied Freezer.
3. Removed Ice Maker.
4. Waited a few hours for ice to melt around back panel & nuts.
5. Removed back panel and the cover over fan and fan motor.
6. Waited many more hours for ice to thaw over fins, wiring, etc.
7. Easily replaced the bi-mental defrost thermostat.
8. Replaced panel, fan cover, ice maker.
9. Plugged in refrigerator and waited a bit.

This worked! Yahoo.

p.s. I am a 65+ year old mechanically minded woman. :-)

Parts Used:

Refrigerator Bimetal Defrost Thermostat

Elizabeth from DELRAY BEACH, FL
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Screw drivers

11 of 11 people found this instruction helpful.

Was this instruction helpful to you?

Cover Pan Crisper(bottom glass shelf and frame) were broken

New part slipped right into the studs and fit perfectly

Parts Used:

Crisper Cover with Glass

anthony from ormond beach, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

13 of 18 people found this instruction helpful.

Was this instruction helpful to you?

Crisper Pan Side Reales Had Cracked

I just slid the new pan in , partselect has the correct part all the time , I repalced my ice maker once and it took 15 min no problem

Parts Used:

Refrigerator Crisper Drawer with Humidity Control

LEVY from HOUSTON, TX
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins

10 of 11 people found this instruction helpful.

Was this instruction helpful to you?

Broken tray

Remove old tray, replace with new tray.

Simple & easy.

Best part is I ordered on Monday & received on Tuesday!

Parts Used:

Refrigerator Crisper Drawer with Humidity Control

Brian from Los Angeles, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

11 of 15 people found this instruction helpful.

Was this instruction helpful to you?

There was no light on in refrig area

Just replaced the switch, but unfortunately that was not the problem; nor was it the bulb....so I am back to square one.
But Parts Select is a great place to order from. Thank you.

Parts Used:

Refrigerator Door Switch