Magic Chef Washer Springs and Shock Absorbers

Suspension Spring

★★★★★

★★★★★

4 Reviews

The suspension spring supports the outer tub and keeps the tub steady during loads that could cause an unbalance. If this part breaks, is worn down or has stretched out and lost its spring, it could cause the load to be off-balance which can lead to excessive shaking, moving, noise, and leaks. For this repair, you will need a 1/4 nut driver, a putty knife, a flat blade screwdriver, and a pair of needle-nose pliers. Disconnect the power supply, fill hoses, and drain hose to give you safe and easy access (have a container nearby for water left in drain hose). This item is sold individually, which is important as you may need to repair multiple springs in your appliance, which carries three suspension springs. As an inexpensive part, we recommend purchasing several at a time, as they can be very useful to have on-hand.

Tub Spring

★★★★★

★★★★★

18 Reviews

This part is used to balance the tub during spin cycle. Sold individually.

Suspension Spring

★★★★★

★★★★★

1 Review

This suspension spring is used with many washing machines. It is made entirely of metal and is seven inches long.

Snubber Ring

★★★★★

★★★★★

16 Reviews

Tub Wear Pads - Package of 3

★★★★★

★★★★★

8 Reviews

This package of pads contains three tub wear pads.

Leveling Spring

★★★★★

★★★★★

2 Reviews

This spring is used on the leveling components in a washer. Please note, this spring may differ in appearance, but functions the same as original.

Suspension Springs - Kit of 6

★★★★★

★★★★★

8 Reviews

This package contains a new set of six springs. The suspension springs in your washer connect to the bottom of tub, and help to hold it in place. If your washer tub shakes, or moves around a lot during operation, it could mean that one or more of your springs are damaged or stretched. You will need to access the bottom of the tub for this repair by removing the front (and possibly the rear) panel. You will also need a pair of locking pliers to remove the old springs and reconnect the new ones. It is recommended to apply a small amount of grease to the bottom of the new springs before you reconnect them to the washer tub.

Suspension Pads - Package of 3 This is a pack of three suspension pads for your washer. The suspension pads in your washer are found underneath the tub and prevent the rotating metal parts from grinding on one another. If your suspension pads are worn out, you will likely hear metal-on-metal grinding, which is an indication they need to be replaced. It is recommended to replace all three suspension pads at the same time.

Motor Pivot Spring This part is the replacement motor pivot spring for your washer. It is made of metal and is approximately 3 inches long and 2 inches wide. The motor pivot spring helps hold the drive motor in the correct position on the motor plate. If your drive motor shakes during use, if the pumps will not operate, or if your washer is excessively loud during operation, you may need to replace the motor pivot spring. Be sure to disconnect the washer from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Counter Balance Spring Kit

★★★★★

★★★★★

2 Reviews

This kit includes 3 springs.