Kenmore Dishwasher Caps and Lids

Videos!

Your Price

$9.27

Stop Clip

★★★★★

1 Review

PartSelect Number PS11770481

Manufacturer Part Number 5304506510

This rail end cap, or dishrack stop clip, is a genuine OEM replacement part for your dishwasher. This part keeps the rack in your dishwasher from sliding out. This is a very easy repair, to complete it you only need a flat blade screwdriver. Use the screwdriver to pry the locking tab open on the cap, located at the front of your upper dishrack. Pull off the end cap and lock the new one into place.

Videos!

Your Price

$35.18

Rinse-Aid Dispenser Cap

★★★★★

31 Reviews

PartSelect Number PS11746426

Manufacturer Part Number WP8558307

The rinse aid cap (sometimes referred to as the dispenser cap), covers the rinse aid dispenser on the dishwasher door. If your dishwasher will not dispense detergent, or it is leaking detergent, there could be an issue with the rinse aid cap. Check the cap and its gasket for any damage or melting. If the cap has melted or it is not sealing the dispenser properly, the part should be replaced right away. This rinse aid cap comes with the gasket, so you should discard the existing gasket and rinse aid cap at the same time. The repair is relatively straightforward, and requires no tools.

Fixes these symptoms

Door latch failure
Leaking
Not cleaning dishes properly
See more...

Videos!

Your Price

$29.56

Rinse Aid Cap

★★★★★

9 Reviews

PartSelect Number PS421128

Manufacturer Part Number 154388801

This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws into the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not drying dishes properly
See more...

Videos!

Your Price

$14.15

Rinse Aid Cap

★★★★★

13 Reviews

PartSelect Number PS11741341

Manufacturer Part Number WP3378134

This cap does not require the use of a o-ring seal.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not drying dishes properly
See more...

Videos!

Your Price

$77.43

Rinse Aid Fill Cap

★★★★★

4 Reviews

PartSelect Number PS2351824

Manufacturer Part Number WD12X10284

This part helps keep the rinse aid the dispenser until its needed.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not drying dishes properly
See more...

Your Price

$19.75

Tub Cap

PartSelect Number PS11703426

Manufacturer Part Number W10795980

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Fixes these symptoms

Leaking
See more...

Your Price

$25.26

LID

★★★★★

6 Reviews

PartSelect Number PS8727344

Manufacturer Part Number 00611322

Fixes these symptoms

Not draining
See more...

Your Price

$26.03

Rinse Aid Cap

★★★★★

10 Reviews

PartSelect Number PS11746567

Manufacturer Part Number WP8564929

This rinse aid cap or fill cap is for your dishwasher and it screws into the jet dry dispenser. Sometimes the cap can become loose and fall out, which can cause it to melt from the heater. If your cap is damaged or missing, this is the part you will need to replace it. It is made of white plastic and is a little more than an inch in diameter. This rinse aid cap is sold individually.

Fixes these symptoms