Admiral Washer Hardware

Agitator Bolt

★★★★★

★★★★★

5 Reviews

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

Washer Washplate Screw

Screw, 8/18 x 3/8 This screw is sold individually.

Screw, 8-16 x 1.000 Sold individually.

Knob Spring-Clip

★★★★★

★★★★★

1 Review

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Cover Screw Sold individually.

Suspension Spring Retainer

★★★★★

★★★★★

2 Reviews

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.

Hose Clamp This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

Gearcase

★★★★★

★★★★★

3 Reviews

This is used in your direct drive washer that has a neutral drain.

Hose Clamp This hose clamp is sold individually.