Washer Bearings

Washer Two-piece Split Ring Bearing

★★★★★

★★★★★

9 Reviews

This is a replacement bearing ring kit for your dryer. The bearing rings are found on the top and bottom lips of the dryer drum. If your dryer is unusually noisy, or the drum will not turn during operation, or if there are marks left on your clothes after a cycle, you may need to replace the bearing ring kit. The kit comes with 2 bearings, one for the top and one for the bottom of the dryer drum. Remove the front panel of your dryer to access the dryer drum for this repair. At this point you can use a pair of needle nose pliers to release the old bearing rings from the drum. Snap the new bearing rings on, and reassemble the dryer to complete your repair.

Washer Tub Seal And Bearing Kit

★★★★★

★★★★★

47 Reviews

Washer Transmission Pulley And Bearing Kit

★★★★★

★★★★★

21 Reviews

Also known as Thrust Bearing Kit. This kit includes the pulley, washer, thrust bearing, 2 upper race washers and 1 lower race washer. These parts are NOT available separately - they are ONLY available in this kit. A worn bearing causes slow or no spin.

Washer Tub Bearing, Rear This tub bearing is for washers. Tub bearing supports the spin basket shaft at the tub. Unplug the washer and shut off the water supply before installing this part. Wear work gloves to protect your hands.

Washer Ball Bearing

★★★★★

★★★★★

1 Review

The tub bearing supports the spin basket shaft at the back of the washing tub. If your washing machine will not spin, is leaking water, or if there is a loud screeching noise during the wash cycle, there could be an issue with the tub bearing. This genuine OEM replacement bearing has a 3-inch outer diameter, and is used to help the tub spin smoothly and to stop the washing machine from shaking during the cycle. NOTE: This part is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly at the same time.

Washer Tub Bearing

★★★★★

★★★★★

4 Reviews

This tub bearing goes in your washing machine. You will find it on the bottom of the outer tub, where the transmission goes through the tub. If you hear metal on metal when the washer is spinning, you may need to replace the tub bearing. This bearing is made of metal, and is approximately 3 inches wide and 2 inches tall.

Washer Tub Bearing Kit

★★★★★

★★★★★

4 Reviews

This kit is used on 2-belt washers. It is recommended to change the seal kit at the same time.

Washer Tub Bearing, Rear Is your LG washing machine not performing as it should? It might be time for a new tub bearing. This genuine part, specially made for LG rear tub models, could be exactly what you need. A functioning tub bearing helps support the spin basket shaft at the tub, allowing your washer to operate smoothly and efficiently - exactly like when it was brand new. Before you consider buying, make sure this part is suitable for your specific washer model. Once you've confirmed it's a match, you're one step closer to a smoothly operating washing machine. Unplug your washer, shut off the water supply, and strap on some work gloves for safety during the installation process. With this high-quality tub bearing, expect the same top-notch performance from your LG washer that you've come to rely on. Let's get your washer back to its peak performance!

Washer Centerpost Bearing And Seal Assembly

★★★★★

★★★★★

3 Reviews

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer Bearing Ball

★★★★★

★★★★★

1 Review

Tub bearing. This part is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly.