Icemaker Stripper Arm WR29X10085

Hi Hubert, Thank you for the question. First you need to remove the ice maker from the appliance.Once removed you can bend or flex the stripper arm a bit to release it from the slot in the front housing of the ice maker. Next release the other end of the stripper from the pin on the end of the ice maker. To install the new one you need to line up the end of the stripper arm with the small hole with the pin on the ice maker, insert the pin on the ice maker into the hole on the end of the stripper arm.Next flex the arm a bit to fit the front of the arm stripper into the slot at the front housing of the icemaker. Good luck with the repair!

Hi Debbie, Thank you for your question. There is a video on our website that you can reference on how to install the stripper arm. The refrigerator in the video may not show exactly like the one you have, but it will give you a general idea on how to install the part. You will find the video under part number PS2378115. I hope this helps. Thank you and have a great day!

Hi Jerry, Thank you for the question. You will find the video under part number PS2378115. I hope this helps.

Hello Diane, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number PS2354686, Hope this helps!

Good Day Bob. Thank you for your question in regards to your unit (Model Number PSS26NG). We would recommend reaching out to the manufacturer at 800-626-2005 as they may be able to help you troubleshoot this issue. Best Regards.

Hi Michael, Thank you for your question. According the GE website, "It is normal to get a slight amount of crushed or broken ice cubes before or while dispensing cubed ice. This is most common after crushed ice was used and you then select cubes. The remaining chips in the crusher blades or the bottom of the bucket get picked up as cubed ice is dispensing. When cubed ice is selected, dispensing cubes requires energizing a lever behind the ice bucket to open a flap and allow whole cubes to come out. If an ice cube gets behind the ice bucket, this can prevent the lever from working. Remove the ice bucket and check for ice that may have fallen behind the bucket. If no ice cubes are behind the bucket, try to dispense ice with the bucket removed. Shut the door, press the ice dispenser and listen for a loud snapping noise. If no snap is heard service will be needed. If you hear a snap, reinsert the bucket and try Cubed ice again. If still no cubes, then check for frozen ice in the bucket. To remove and check the ice bucket: Pull the ice bin out by lifting it up in front and sliding it forward. Check for and remove clumped or shaved ice in the bin. If ice remains, run the bin under warm water until the ice melts completely. Dry the bin thoroughly. Reinstall the ice bin by pushing it all the way back against the freezer wall. Allow time for Icemaker to cycle again – to make cubes. Select CRUSHED ICE and then CUBED ICE. Try the dispenser again" I hope this helps. Thank you and have a great day!

Hello Diane, thank you for contacting us, In order for us to locate the correct parts and repair information we will require the model number of the fridge. Once you have located the model number please feel free to resubmit the question and we will be happy to help you. Look forward to hearing from you!