Infinite Switch W11129442

Hi Jamie, Thank you for your question. If you turn the burner on to a lower temperature and it goes to a higher temperature instead, then there is an issue with the switch that controls that burner and it will need to be replaced. The part number listed under your model number for the switch is PS12114485. If you would like to place an order for it, you may order it either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.

Hello Curtis, thank you for contacting us. Based on our research, the infinite switch, part number PS12114485, and the knob, part number PS11765471, are compatible with your model. We hope this helps!

Hi Dave, Thank you for the question. Each burner has a different switch. The Left Front is listed as PartSelect Number PS12114485. The Left Rear is PartSelect Number PS11770037. Right Front is PartSelect Number PS11731368 and Right Rear PartSelect Number PS11769788. We hope this helps!

Hi Kyle, Thank you for your question. If you have replaced the burner switch and the burner still heats on high regardless of what setting it is on, then you either have a defective switch or the issue may be with the element. You will need to test these parts for continuity with a multimeter on the Rx1 setting to see if they are operating normally. Before removing and testing these parts, unplug the range from the electrical outlet. For the burner switch, place the multimeter's probes on the L1 and H1 terminals. Once you have completed that test, touch the probes to the L2 & H2 terminals. If your test results indicate that there is no continuity between one or both sets of terminals, you need a replacement infinite switch. For the burner element, touch each of the terminals one at a time with one probe while holding the other probe to the outside surface of the element. If either terminal shows continuity, it is defective. To test the entire element for continuity, place each of the probes on the terminals, one on each. The exact reading you should receive varies between models, refer to your owner’s manual to determine what yours should be, but if any element has a reading outside of 19 to 115 ohms, it is defective. If you do not receive the correct readings from the tests above or find damage on your element, you will need a replacement surface burner element. We hope this helps!

Hi Josh, Thank you for your question. Yes, this switch operates the left-front burner or triple burner. We hope this helps!

Hello Scott, thank you for reaching out. The issue seems to be with the Infinite Switch and you may need to replace it, the part number is PS12114485. It turns the surface element on and off and controls how much heat the element produces. If that does not help, we would recommend replacing the Triple Radiant Surface Element, part number PS11764923. We hope this solves your problem!

Hello Donnie, thank you for reaching out. According to our research, the switch that controls the right front dual element is PS11731368. If you need help placing an order, customer service is open 7 days a week!

Hello Harman, thank you for reaching out. This infinite switch controls the left front burner. The surface element switch associated with the left knob on the right side is part number PS11770037. We hope this information helps!

Hello Mark, thank you for getting in touch. The infinite switch, part number PS11749818, is compatible with your model number. We hope this helps.

Hi Mike, Thank you for your question. The part number for the right-front infinite switch is PS11731368. We hope this helps!