TS518SW (P1183701W) Amana Refrigerator - Instructions

The repair was very simple and the refrigerator now looks almost new. We are very pleased with your service and the fast delivery time. We give it 5 stars.

Lifted both drawer runners removed the broken post, put new post in place. Job completed in lest than two min.

At first I went to a local part supplier and they didn't have it in stock but could order it for me for $55.00 plus $10.00 to ship it. I told them I would have to think about it. I went home and got on the computer and found your web site and was I shocked when I saw the same part listed for $6.98 and $7.00 to ship it. You guys saved me $50.00. The part arrived in two day and took 5 min. to install. I now have light in my refrigerator. Thank you.

I removed two screws holding the assembly. removed the assembly then toke the roller and bracket out of the houseing and replaced with new part. reverse the procedure for installation.

Cleaning up the broken glass was the hardest part (Even went into the garbage disposal!). But ordering a replacement shelf was as easy as typing in the refrigerator model number on the PartSelect website. Easy installation after prompt shipment arrival by FedEx.

Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!

Loosened all the screws and pulled the old gasket off. It was fairly easy to get the new one in place. After I had it on it did not seal well so I had to use a hair dryer to get the seal tight.

First removed the screws holding the broken handle in place, then placed the new handle in position and attached with the new screws. The part arrived the day following online ordering - very quickly!

A very cold and brittle switch in a 17 year old fridge. Used screwdrivers to pry out with some resistance Had to cut the molded plug in half and split wires, because replacement contacts were farther apart than the original. End result, works great.

A staff member at the group homes installed the handles with no problems at all, other than the original screws were quite well seated, and took some time to remove them. The replacement was easy and faultless.

The only problem was that we received Freezer Door handles instead of Refrigerator Door handles. But it's all good - the freezer handles were looking a bit shabby anyway.

I entered the model number and was easily able to find the replacement part I needed. It arrived two days later and I installed it and now my fridge works as good as ever. Thanks I felt so smart.

After disconnecting the electricity. I followed the instructions as indicated in the "HOW TO" article on the website. I used a steel putty knife and pried the light switch out of its retaining hole. I worked the right side the most since this is the side with the retaining clip. After I removed the switch I transferred the two electrical outlets to the new switch and easily snapped it into place. Engaged the electric power and tested the switch.

Removed broken rails and replaced with new rails

disconnected el. power to fridge. pried out broken switch with small screwdriner and pulled out w/water pump pliers. installed new switch and pressed into opening.

Went together like a breeze. Only problem now is need to clean rest of frig really well to match handle.