SCA1000HCC - Instructions

First I had to accept the fact that the unit was designed to keep non-professional people from doing any repairs. The switch was installed in such a manner that I had to break the mounting to remove the switch, then drill a hole in the mounting to secure the new switch in place.

When trying to replace the light bulb for the underneath night light, I damaged the female receptor plug by not inserting it gently and straight on, and thus couldn't insert the bulb. So, I had to replace the receptor which is part of a the reflector assembly with the small attached plug cord. Once I was able to unscrew the glass cover and move the existing reflector panel aside to see how it fit together, it went well and is now working fine. One hint in replacing bulbs is to order the correct one, since there is another bulb for the interior light for the microwave which uses a different bulb. Be sure to order the correct one. Also, push them in gently but firmly right on center.

Read other folks on your site on how they did it and I followed their directions. About 30 minutes and it was done. Figured I saved lots of money. Thanks

Problem was due to a faulty door switch. Replaced with a new switch and the microwave now works fine! Only thing that was tricky was that LG uses the hex screws with a peg in the middle to keep the microwave cover on. Had to use a small screwdriver and pliers (on the screwdriver) to unscrew the screws.

the problem was the mounting bracket that was installed when the house was built ,was not the bracket that came with the microwave. It was used to step the microwave out 3" in front of the other cabinets for the style that they were using then. so when I was installing the new cabinets I didn't want that style, so I ordered the original mounting bracket. It was a perfect fit and the install went great

The Halogen Light Bulbs for lighting the area below the microwave seemed to be burned out. I order new bulbs but by the time they arrived the old bulbs appeared to be working again. Not sure why this happened but I have new bulbs if they become burned out for good at some point.

Checked all sensors with a multi-meter, found the thermostat to be the problem, no continuity.

Ordered the part on Monday, it was delivered on Wednesday, only paid for standard shipping. All I had to do was put it in, right part, back to new!

Ridiculously easy, unscrew, and change bulbs. Having the correct bulbs made all the difference, I did not have to waste time looking for the correct one.

Removed screw holding faceplate that covered bulbs. Next inserted new bulbs into sockets.
Turned on surface light to insure they worked - they did. Re-attached faceplate.

took glass cover off being an electrician and saw lamp or bulb was burned out. googled your site and with model number.went on partselect found lamp,orderd it.2 days later lamp arived installed lamp. So easy no running around or making several calls

Received my replacement Tray,Glass in only 2 days. Opened it and placed it in the Microwave. Yep, it was that easy!

Screw out-old bulb out- new bulb in- screw back in!!!!!

Removed old bulbs replaced with new. Bulb fit perfect thank you

removed screw from inside wall. removed leftover board & replaced with new board & screw. good as new!!!