SCA1000DWW03 General Electric Microwave - Instructions

Placed the new tray in the microwave.

opened the access door. It took some tugging to get the old bulb out, and is was awkward getting the prongs on the replacement bulb lined up and pushed in, but it was accomplished in about 10 minutes. You had exactly the right information on a change in the part number that was made by GE, and you shipped the correct bulb the same day I ordered it.Good job. N R Brown

This is the tray the glass cooking tray rest on and rotates the glass during cooking. The metal tray was installed upside down. The rotating glass tray was not properly installed. The oven was at a very high temp. and the weight of the utensil on the glass was not supported correctly. Result, big " pop " and broken glass tray. Note this is the second glass repaced. The first one dropped while removing it from the oven. It stuck to the bottom of the cooking dish and then fell to the floor. Pop, big breakage. Maybe you can learn from my mistakes.

I'm writing because I have never in my life had such an easy time finding a part, ordering it, and receiving it! Your service is truly unbelievable. I still don't believe it and I experienced it. Nothing went wrong and it could not have been easier. Please don't go away.

placed plate on carousel

Just like the directions said. Very simple.

Opened the lid over the bulb by removing one screw. Removed old bulb; a bayonet type with delicate prongs. Inserted new bulb. Best to turn off circuit breaker toi the micro for safety reasons.

Plastic broke off where the screws are inserted.

Removed tray from shipping container and installed in the microwave.

Snap the plastic trim piece from the inside of the door off.took broken latch out and put the new one in.PS your part came really fast.Thanks

I first removed the top vent cover by pushing upwards slowly as not to break the plastic tabs holding it it place. Then lifted the door off of the hinges. Laying the door flat, I then inserted small screwdrivers (eyeglass repair size) into the "Mask frame" to push the "J" tabs inward. Do slowly as they get brittle with age. Remove the 8 small screws holding the door assembly to the plastic frame. You'll see the 2 screws holding the handle in place. Remove them, install new handle, reverse process. About 35 minutes.

The Vent Grill came off when the two Tabs crack and broke off. The New replacement from PartSelect arrivied. Took the part out of package and replaced the two screws on top of the Vent. Had to push the Vent in to align the first screw. Pushed the side of the vent to align the Tab and put the second screw in. The fit was perfect

Took item from sealed box and removed protective bubble wrap. Placed tray in microwave, aligning tray with turntable sprockets. Perfect fit, perfect match! And the part arrived in three days and was very competitively priced. What more is there to stay? Will use PartSelect for other replacement parts. No brainer!

bought a fuse but that didn't solve the problem. Guess I need a new microwave

Removed the door, removed the old choke cover (breaking all the stap catches), removed the slide door latch assembly from the spring (the most difficult task) then reassembly of the latch to spring, sliding into the grooves along the inside of the door, the installing the new choke cover (very easy with the new one) taking care not the break any of the staps. Easy enough! Another difficult task was to re-install the door to the frame. It appears that the lower "hinge" is slightly bent down to allow easy install but the door now makes a slight sweeking sound when opening and closing.