All Installation Instructions for Samsung Refrigerator RF267AEPN

Freezer handle had broken free from the left side of the door.

On both sides of the door there is a pop off cover that houses the broken mechanism. I popped off the cover and exposed the screws the attached the handle to the opening mechanism. removing those screws I removed the handle from the freezer door. I replaced the broken plastic piece on the handle . Reattached the repaired handle assembly to the door with the 4 screws. Reinstalled the cover.

Parts Used:

Handle End Cap - Gray - Left Side

Kathleen from FLORISSANT, MO
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Refrigerator was too cold - down to 18 degrees Fahrenheit.

Removed shelves. Removed back cover. Removed old sensor. Installed new sensor. Replaced back cover. Replaced shelves. Works fine.

Parts Used:

Temperature Sensor

Bill from RALEIGH, NC
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

5 of 14 people found this instruction helpful.

Was this instruction helpful to you?

Spring replacement on Mullion Door

had to replace the spring on the Mullion door . the how to video helped however the demonstration shows putting the spring on in the opposite way that my door calls for, so just I turned the spring around and done, other than that easy as pie.
thanks
Chris F.

Parts Used:

Spring PIN - French

Chris from YORK, SC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

french door mullion busted

Piece of pie! Took of the screw caps, the screws, disconnected the wire switch and reversed direction with the new one. 10 minutes tops.

Parts Used:

French Assembly

JOHN from ARLINGTON, MA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Spring broke on the side by side door.

Very carefully used the pliers to put the spring in the two slots with the door mullion. Works like brand new

Parts Used:

Spring PIN - French

Door Mullion Spring

Jerry from Danville, IA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

1 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Brokjen spring

Lifted out the broken part and replaced with new spring.

Parts Used:

Door Mullion Spring

Sharol from Culdesac, ID
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

brackets broke that hold the tiltable tray for the freezer

Extremely simple, remove the old tray brackets and snap the news one in place. Put just enough pressure till you here them click in place.

Parts Used:

Support - Guard Freezer

Jerry from Manvel, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

french spring broke

after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell

Parts Used:

Door Mullion Spring

RYAN from RIVERBANK, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

We misplaced the mounting screws for our handles while moving.

It was easy! I just used an alan wrench to losen the side bolt, then slid the handle into the new mounting screws that I had hand-screwed and then tightened it all up.

Parts Used: