All Installation Instructions for General Electric Refrigerator PFSF6PKXGWW

Replaced damaged freezer drawer rails

Remove the front of the freezer door according to the instructions in the manual. This will require an open end or socket style wrench for the four bolts, two on each side. Use a flat blade screwdriver to push in the plastic tab at the rear end of each drawer rail. Pull on the rail to slide it out. Install the new rail marked L on the left side and the one marked R on the right side. Push them in where the old ones were located until they are locked into place by the tab on each side. Verify they are secure before re-installing the drawer front.

Parts Used:

Assembly RAIL-SLIDE LOW R

Assembly RAIL-SLIDE LOW L

Brian from Greeneville, TN
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

no turn on

with my hands

Parts Used:

Refrigerator Ice and Water Filter

edward from orlando, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

filter change

easy easy easy!!!!!

Parts Used:

Refrigerator Ice and Water Filter

Mary from Elk Grove, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

water tasted funny

Simply twisted off the old water filter, unwrapped the new one and twisted it on.

Parts Used:

Refrigerator Ice and Water Filter

Charles from Enterprise, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

needed to replace the filter

replaced the filter with the new one i purchased

Parts Used:

Refrigerator Ice and Water Filter

richard from asheboro, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Poor water and ice taste, filter a few years old.

Very simple, I followed instructions sent with the filter. Twisted old filter clockwise 1/4 turn to remove. Filled new filter with water, lined up arrow on filter to arrow on refrigerator, and then turned 1/4 turn counterclockwise. Filter raised and seated itself. Wiped few drops of water from refrigerator shelf.

Parts Used:

Refrigerator Ice and Water Filter

David from San Antonio, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Filter needed replacing

Folowed instructions

Parts Used:

Refrigerator Ice and Water Filter

W Craig from Diamondhead, MS
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

replaced filter

none required

Parts Used:

Refrigerator Ice and Water Filter

donnie from metairie, LA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

on the french doors my granddaughter kept turning the inner seal bar when the door was open and when we went to close it it was in the wrong position and eventually the upper hinge broke

I took a small straight screw driver and popped the cap case off, removed old hinge and installed new hinge and snapped the cap back in place.. took all of 30 seconds

Parts Used:

French Door Hinge

CAP CASE FRENCH

david from bridge city, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Spring broke

Installed new spring pin and spring. Took only 2-3 minutes. It was more difficult to get the correct part since the spring pin was the only number listed in the part diagram and I actually needed the spring and had to call customer service to get the correct part number.

Parts Used: