All Installation Instructions for General Electric Dishwasher PDW8400J03CC

clips on wheeles were broken

replaced clips that were much better made.

Parts Used:

Dishrack Rollers and Axles - Kit of 8

sean from oakland gardenns, NY
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Couldn't drain water

I connected one end of hose to the drain using a hose clamp and screwdriver then connected the other end to the dishwasher using anouther hose clamp and a screwdriver..

Parts Used:

Drain Hose

Janice from Rockville, MO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

4 of 9 people found this instruction helpful.

Was this instruction helpful to you?

worn wheels on upper rack

parts were easy to find and the repair was a breeze. Thanks for your help.

Parts Used:

Upper Rack Wheel

Paul from Oakland, NJ
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

4 of 9 people found this instruction helpful.

Was this instruction helpful to you?

Detergent cap would not stay closed

After removing the screws, the front of the dishwasher easily came off. I put 2 screws back in to hold the control panel in place. I did not want that to dangle while replacing the part. The part came off easily after removing the screws. Everything went together easy.

Parts Used:

Detergent Dispenser with Rinse Cap

Michelle from Carlisle, PA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

I'm told I had a typical pump seal leak.

I unplugged and removed my dishwasher and followed the instructions extactly repairing the pump and replacing the parts I had just received. I torgued the ring to the specified amount, installed the pump and found the impeller could not turn. I dis-assembled it all again and loosened the ring to allow the impeller to turn, reinstalled it and when I initiated the wash cycle, water began running wildly. Next step, replace motor and pump as the pump motor shaft has gone out

Parts Used:

Dishrack Rollers and Axles - Kit of 8

Impeller and Seal Kit

Joseph from Tucson, AZ
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

The detergent dispenser latch was broken

The repair was easy. Removed all the screws from the inside door panel, approx. 11. Watch out for that last screw as there isn't anything else holding the outside panel, inside panel and control panel together other than those screws. I then unplugged the old dispenser backed out another 6 screws and replaced the old dispenser with the new one. Put it all back together within about a half hour.

Parts Used:

Detergent Dispenser with Rinse Cap

KEVIN from MACKINAW, IL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

The door on dishwasher soap dispenser broke.

Repaired the soap dispenser.

Parts Used:

Detergent Dispenser with Rinse Cap

Eric from SIMPSONVILLE, SC
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Heat shield on lower spray arm came loose and blocked spray arm from turning

Followed instructions on how-to video on website on how to remove and replace lower spray arm.

Parts Used:

Lower Spray Arm - Gray

Jack D from CLEBURNE, TX
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Hinge arm link wore out

Used Phillips screwdriver to undo brackets that keep dishwasher in place. Pulled out dishwasher from underneath the counter. Placed hinge arm in spring, hooked spring onto clip, placed hinge arm in clip. Put back dishwasher under the counter and screwed in place. Took all of 15 minutes. Saved 185.00 for service call.

Parts Used:

Hinge Arm Link

Samuel from LAS VEGAS, NV
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Holes in old dishwasher basket

The replacement dishwasher basket easily fit in my dishwasher. Easy to order. Quick delivery. Highly recommended.

Parts Used:

Dishwasher Basket Assembly Silverware

James from FAIRFIELD, CT
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Food particles had started stopping up spray arm and get them out.

Pulled old spray arm off and snapped new one on. Less than 3 minutes and works great. Dishes are cleaner now.

Parts Used:

Lower Spray Arm - Gray

carla from valdosta, GA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Started to have a leak

Pull out the old, died gasket. Clean out track that holds gasket. insert new gasket.

Parts Used:

Tub Gasket

Ron from TYNGSBORO, MA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Dishwasher was not starting

Replaced interlock assembly as one of the possible causes. The replacement was easy, but this was not the final fix. I also replaced the water inlet valve, flood switch and finally found that there was large calcification within the drain tube assembly (not visible, but was blocking water). Got a new flexible tubing and new drain hose, plugged everything together and the dishwasher runs like new now. Watching for a potential leak from the drain tube to drain hose connection and mya need to tape it up, but so far so good...

Parts Used:

SWITCH INTERLOCK Assembly

Prasad from LEAWOOD, KS
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Socket set

1 person found this instruction helpful.

Was this instruction helpful to you?

Our dishwasher lower arm had become clogged

HAHA! The easiest repair we have ever done! Took it out of the box, snapped the old arm loose, put the new arm in and -- the dishwasher works like new! Thank you!

Parts Used:

Lower Spray Arm - Gray