MHE14XMQ3 Roper Microwave - Instructions

I removed the broken tabs with a screwdriver and snaped in the new cover replacing the screws once I had it in place. the entire job took less than 5 min.

Took screws off of old vent grille and installed new one. Very easy except my old one was a shiny black grille and this one has a matte finish. Description did not say which but I am fine with the part.

old vent off screwed new in less than a minute

I, carefully, inserted the bottom tabs into the appropriate slots. I then rotated the vent piece up and into place under the top lip of the Microwave. Once positioned I installed the screws required to hold the piece in place. Very simple replacement. It gave me a chance to clean the grease behind the vent.

took old vent grill and tabs off using phillip screwdriver. started putting new grill on and it wouldnt go on. got to looking and there are two more screws that you have to loosen up so the grill will go into place these two screws are between the two tabs at each end. caution do not over tighten the screws it will break the tabs. overall easy to install.

Having the correct model number helps:
Just place the parts in the microwave and it worked.

Just remove the old one, inserted the new grill and tightened the screws on the top of the microwave.

I was sent the wrong fuse by you. I had to procure a fuse in another manner. Very disappointing. The repair was simple. It just took longer because of the failure to send the correct fuse.

Unscrewed existing screws, removed old grill, fit new grill into proper slots, reinstalled and tightened screws.

Open compartment, installed bulb, closed compartment

took it to Buttermore appliance in Auburn Indiana and he changed the fan and added another fuse

Took the front off and behind a plate was the fuse, so I replaced it for what good that did!!!

I removed the screws to the old handle and screwed on the new one

The repair was easy, I just took off a few screws and found the broken latch spring. The real story is how easy it was to find the replacement spring from Partselect! I couldn't believe they had it, and even better yet, I ordered it one afternoon, and it came the next day with normal shipping! Unbelievable! Then I just popped it in and replaced the covers I had removed and it was working again!

The lady in the Nova Scotia call center should get all the credit for being able to identify the part I needed from only the very limited information I was able to give her. Employee of the month for her. She also had such a great can do attitude. Lawence Baier