ME18H704SFS Samsung - Instructions

Other tools that are usefull long needle nose pliers, long thin blade screw driver and small magnetic flashlight. Place the microwave on a work bench and remove the case it cover 3 sides. Place the microwave on a chair so it can stand with the controls up. You are replacing the lower door microswitch. The switch is located behind the control panel in the lower part of the area. The switch is several inches inside this area and your hands will not fit. Take care when moving wires and a couple of sensors. Use the thin blade screwdriver to release a tab holding the switch in place. Do not break this tab. Take the needle nose pliers and remove the switch. Put the wires on the new switch, open the door a short distance so a door lever moves enough to put the microswitch back into the bracket.

easy to install

Pulled the filters down, measured and went on line- done. was fast to find the part and easy to order...

Ordered (most difficult part of repair, because I wasn't sure the one I ordered would fit), opened box, removed padding, opened microwave oven door, lined up center indentations with center and my repair was complete. Placed a cup of lukewarm coffee on the tray, closed door and pushed auto 30 seconds. The cup went round and round on the plate that went round and round and then, the END chime sounded. Success! Lukewarm coffee has been transformed to HOT coffee on the newly installed cooking tray.

I used my pocket knife to open the package. I opened the door and removed the plate and set the guide down and put the glass plate back.

Was estimated for $369 part plus labor.
I purchased part from You for $114 inclu tax)
My son replaced new part with just Two Screws !!!!!
Thankyou So Much
Will recommend always

I ordered a replacement piece. Fits perfectly and rotates as it should. It arrived earlier than planned.

We did not use the part, the spring fell off inside the door. We kept the part just in case

I took off the inner plastic frame of the door, removed the broken part, hooked the spring up to the new latch and replaced it into the proper alignment holes, and works perfectly. It was less than a 5 minute repair.

Use knife to peel back molding around latch openings. Pull down on plastic latch part, pull out bottom and tilt up to remove broken part from spring. Tilt top of new part inward and connect tab to spring. Push in bottom of latch and snap. Replace the molding by pushing all around the door frame.

After removing the door from the OTR microwave, we slid out the old latch, slid in the new, & reattached the spring. Replaced the door & DONE.

Used a putty knife to take off the edging inside the door to have access to the latch. Put the new part in and attached the spring. Replaced the edging and job was complete.

Got part from you in one day - great- watched utube video on removing molding and reinstalling. Video was longer than time to fix all need to do was remove molding and install the door latch - it is made of plastic with a hook on which to attach spring. Hook breaks and therefore door does not close

Replaced the bulb

To replace the light bulb was fast and easy. All I had to do was unscrew one screw and place the bulb in! Quick and easy, and simple!