ME11CB751012AC Samsung - Instructions

We did not use the part, the spring fell off inside the door. We kept the part just in case

I took off the inner plastic frame of the door, removed the broken part, hooked the spring up to the new latch and replaced it into the proper alignment holes, and works perfectly. It was less than a 5 minute repair.

Use knife to peel back molding around latch openings. Pull down on plastic latch part, pull out bottom and tilt up to remove broken part from spring. Tilt top of new part inward and connect tab to spring. Push in bottom of latch and snap. Replace the molding by pushing all around the door frame.

After removing the door from the OTR microwave, we slid out the old latch, slid in the new, & reattached the spring. Replaced the door & DONE.

Used a putty knife to take off the edging inside the door to have access to the latch. Put the new part in and attached the spring. Replaced the edging and job was complete.

Got part from you in one day - great- watched utube video on removing molding and reinstalling. Video was longer than time to fix all need to do was remove molding and install the door latch - it is made of plastic with a hook on which to attach spring. Hook breaks and therefore door does not close

My repair went terrible as I was sent the wrong motor 2 times. My stove sat in the middle of my small kitchen for 2 weeks. Finally the 3rd was the correct one except I didn't have the right nut so I waited another day for that to be sent. Everything working good now, I just hope the bottom fan doesn't go out after this experience.

It was a over the range microwave It had to be removed off the wall. Once down I removed the bottom plate and then removed the touch control panel. Per the instructions in the user manual tested the transformer it was ok. Next tested the capacitor it tested bad and also the diode tested bad. The parts were ordered from you. The parts installed easily. Reassembled the microwave and tested. Unit no longed tripped the AC breaker and worked heating some water. Installed the unit back above the range.

To replace the light bulb was fast and easy. All I had to do was unscrew one screw and place the bulb in! Quick and easy, and simple!

Called Maytag regarding the latch. Was told I had to order an entire new door that would cost around $170 before shipping and handling. Went on partselect and foundt he part for $2.02. Big difference in price. Very easy to install. Hardest part was getting the spring back on. Would definitely recommend to friends.

Replaced the bulb