All Installation Instructions for LG Refrigerator LSC27921ST

The ice tray had warped and dumped water, which then froze down through the ice bucket and below.

To replace the warped tray, I found the service manual (pg. 124 below) which took some interpreting.
Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards.
The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and then insert the new tray. Proceed in reverse. Takes only a few minutes.

/Users/grf/Desktop/fridge ice tray.pdf

Parts Used:

Ice Tray

George from ATLANTA, GA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

8 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Replace Gasket on refrigerator door

The replacement gasket does not have as strong a magnet as the original one. I removed the old one carefully so as not to cause more damage in case I have to put it back. Using Tongue suppressor I pushed new gasket into place and put a thin coating of protelem jelly on the gasket. I just have to make sure the door is closed each time to be sure of good seal.

Parts Used:

Gasket Assembly,Door

Curtis from DEMOPOLIS, AL
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

6 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Right side door creaky squeaky annoying

Took off door per normal instructions.
Removed the old stopper and hinge assembly (the hard rubbery parts had worn enough against each other to cause the annoying sound when opening and closing the door).
Inserted the new stopper and hinge assembly.
There was no locking nut on the newer part, so just had to level the fridge door without that part of the instructions (from normal LG instructions)
Overall easy for a non-handy person and the annoying sound is gone.
Wife is happier now.

Parts Used:

Door Stoppyer Assembly

Refrigerator Hinge Assemblylower

Chris from MURFREESBORO, TN
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench (Adjustable)

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Noise coming from refrigerator

Opened the back and noticed a fan blade off making the motor unbalanced. Ordered a new fan and motor and went to (you tube ) that explained the whole procedure. Couldn’t get any easier.

Parts Used:

FAN ASSEMBLY

Herb from YUMA, AZ
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench (Adjustable)

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

whater valve whith a defected selenoid and water leaks.

First ,I unplug the refrigerator .
2nd i remove the back cover, clean the dust.
3th disconnect the water line, remove the all valve..
4th unplug all the wires and code ea with a No,remove the water lines
5th replace the valve reconnect the wires and water lines.replace the
back cover at last screw back the water line.check for water leaks .
i found ease the valve replacement installation.
.Thanks for the video.

Parts Used:

Water Inlet Valve Assembly

Albert from NORTHRIDGE, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set, Wrench set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Our shelves didn’t fit right and they leaned!

Just replaced the old shelves with new

Parts Used:

Shelf,Freezer

Dianne from TEMPLE, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Cover broken when attempting to remove it so water filter could be replaced.

It was a "snap to complete it" inasmuch as the part just snapped in.

Parts Used:

COVER,LAMP

John from CAMDEN, NC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Water had reached its recommended service life..

Closed valve to water supply line; Removed contents of top shelf. Removed top shelf by sliding it out. Unscrewed old water filter and screwed in new filter. Replaced to shelf and contents in reverse order. Opened water supply line.

Parts Used:

Refrigerator Water Filter LT500P

Willard from COMPTON, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Refrigerator would not produce ice or water

Replaced water pump assembly, all compression fittings easy to put together

Parts Used:

Water Inlet Valve Assembly

Frank from TRAVERSE CITY, MI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Left door when opened the light wouldn’t come on. Checked the light, ok. Ordered push button switch

Removed the cover 2 screws
Squeezed the 2 side sleeves and removed
Snapped in new button, replaced the cover. Done

Parts Used:

Push Button Switch

Richard from TULLY, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Wrench (Adjustable)

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

gaskets worn out again

replaced gaskets for the second time in four years

Parts Used:

Gasket Assembly,Door

Keith from Phoenix, AZ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

The ice maker door stay open. And not close back.

So easy that my 13 years old son replaced it.

Parts Used:

SOLENOID ASSEMBLY

Toai from Monroe, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

replace hand screw

unfortunately my fridge stopped working. I purchased another but wanted to try and repair the old one. when ew one arrived, the old one was supposed to be put in garage but instead was hauled away. Had delivery return next day but they had as already removed and lost the handle screw for the bottom freezer and the screw that holds handle in place. ordered the handle screw and picked up the nut. very simple to install the screw and put handle back on.

Parts Used: