All Installation Instructions for LG Refrigerator LFC22770SW

Door switch would not turn on interior refrigerator light.

I had previously watched a YouTube video (do this first!!) on a similar Kenmore model so I knew what to look out for: (1) turned off power, (2) took thin putty knife to slip under outer lip of switch (most screwdrivers are too thick), (3) wiggled switch at front end to release the tab, (4) unplugged from the socket, (5) plugged in new switch, (6) popped new switch back into door, (7) turned on power. Voila !! Super easy. I couldn't believe it.

Parts Used:

Refrigerator Door Switch

Jane from SHORELINE, WA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Refrigerator not cooling

Used a screwdriver to remove covers. Used a blow dryer to defrost coil in freezer. Cut zip tie and removed old controller assembly. Inserted new controller assembly and secured with zip tie. It took 24 hours for the fridge to cool completely. Now it works fine.

Parts Used:

Defrost Thermostat

Richard from Ashland, KY
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Ice maker quit working

Plug in the replacement ice maker to the socket in the frig, fit the back of the new ice maker into the slot to the rear, attach with 2 screws saved from removing old ice maker. Simple.

Parts Used:

Refrigerator Ice Maker Assembly

Richard from MINNEAPOLIS, MN
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Blower motor out on condenser

followed detailed movie from Utube video

Parts Used:

Evaporator Fan Motor

George from WHITE BIRD, ID
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

4 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Freezer frost accumulation

After noting frost in freezer Right rail started to jam. Noted freezer door was closing crooked. Rail replacement resolved issue. It had been frosting up for some time so Rail must have been broken for a while. Check door seals they were not closing flush.

Parts Used:

Slide Rail - Right Side

Peter from Sewell, NJ
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Decor tray broke

Did repair it yet part came damaged and I’m still waiting for customer service to get back to me for the last week and half so my part came damaged and it’s still not fixed

Parts Used:

DECOR,COVER

Paul from WILKES BARRE, PA
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

light didn't come on when the door was opened

I took a very thin bladed screwdriver and took the old part out -carefully.
The new part fit in quite easily.

Parts Used:

Refrigerator Door Switch

William L from SUMAS, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Switch stops working

Replace with new switch. this is the third switch i have replaced in 10 years. the only part, besides a light bulb, that has gone bad. obviously this is a problem with this model for Kenmore, or just poor switch design.

Parts Used:

Refrigerator Door Switch

David from PENNSVILLE, NJ
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Light switch for refrigerator not functioning

Followed instructions online

Parts Used:

Refrigerator Door Switch

shirley from ONALASKA, WI
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Door light switch, 3rd one I have replaced in 6 years made in China.

Easy install, small screwdriver under back of old switch push out and pull out with small pliers. unsnap the old plug and install new. YOUR DONE

Parts Used:

Refrigerator Door Switch

Charles from CURWENSVILLE, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Replace switch

Read previous tips
Taped off area around switch to protect surface
Used putty knife to extract switch
Used screwdriver to separate connector from switch
Plugged in connector
Pushed switch assembly into opening
Removed tape

Parts Used:

Refrigerator Door Switch

Dean from HILLSDALE, MI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Light quit coming on when door opened.

Unplug from wall receptacle. Pry switch out with screwdriver while pushing on inner tab. Then disconnect electrical plug.

Parts Used:

Refrigerator Door Switch

Calvin from Northome, MN
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Lights didn't come on when door was opened

I have moderate to good mechanical skills, but getting the old switch out was a sizeable challenge. Since this switch suffered some damage during extraction, I was lucky to have ordered a new one to replace it. Reinstall took approximately 90 seconds. PartSelect saved me an expensive service call.

Parts Used:

Refrigerator Door Switch

Philip from Ashland, MA
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

door slight switch failed

Covered the sidewall with tape to protect. Pried the switch out with knife blade and removed electric plug with needle nose pliers. placed plug in new switch and pushed switch into the hole in the side wall. Took about five minutes.

Parts Used:

Refrigerator Door Switch